Stephen A. Lyon’s research while affiliated with Princeton University and other places

We report on low-frequency measurements of few electrons floating on superfluid helium using a bespoke cryogenic cascode amplifier circuit built with off-the-shelf GaAs High-Electron-Mobility Transistors (HEMTs). We integrate this circuit with a Charge-Coupled Device (CCD) to transport the electrons on helium and characterize its performance. We show that this circuit has a Signal-to-Noise ratio (SNR) of $\thicksim$ 2$\frac{e}{\sqrt{Hz}}$ at 102 kHz, an order of magnitude improvement from previous implementations and provides a compelling alternative to few electron sensing with high frequency resonators.

Superconducting qubits are a leading system for realizing large-scale quantum processors, but overall gate fidelities suffer from coherence times limited by microwave dielectric loss. Recently discovered tantalum-based qubits exhibit record lifetimes exceeding 0.3 ms. Here, we perform systematic, detailed measurements of superconducting tantalum resonators in order to disentangle sources of loss that limit state-of-the-art tantalum devices. By studying the dependence of loss on temperature, microwave photon number, and device geometry, we quantify materials-related losses and observe that the losses are dominated by several types of saturable two-level systems (TLSs), with evidence that both surface and bulk related TLSs contribute to loss. Moreover, we show that surface TLSs can be altered with chemical processing. With four different surface conditions, we quantitatively extract the linear absorption associated with different surface TLS sources. Finally, we quantify the impact of the chemical processing at single-photon powers, the relevant conditions for qubit device performance. In this regime, we measure resonators with internal quality factors ranging from 5 to 15×106, comparable to the best qubits reported. In these devices, the surface and bulk TLS contributions to loss are comparable, showing that systematic improvements in materials on both fronts are necessary to improve qubit coherence further.

Over the past decades, superconducting qubits have emerged as one of the leading hardware platforms for realizing a quantum processor. Consequently, researchers have made significant effort to understand the loss channels that limit the coherence times of superconducting qubits. A major source of loss has been attributed to two level systems that are present at the material interfaces. It is recently shown that replacing the metal in the capacitor of a transmon with tantalum yields record relaxation and coherence times for superconducting qubits, motivating a detailed study of the tantalum surface. In this work, the chemical profile of the surface of tantalum films grown on c‐plane sapphire using variable energy X‐ray photoelectron spectroscopy (VEXPS) is studied. The different oxidation states of tantalum that are present in the native oxide resulting from exposure to air are identified, and their distribution through the depth of the film is measured. Furthermore, it is shown how the volume and depth distribution of these tantalum oxidation states can be altered by various chemical treatments. Correlating these measurements with detailed measurements of quantum devices may elucidate the underlying microscopic sources of loss.

Superconducting qubits are a leading system for realizing large scale quantum processors, but overall gate fidelities suffer from coherence times limited by microwave dielectric loss. Recently discovered tantalum-based qubits exhibit record lifetimes exceeding 0.3 ms. Here we perform systematic, detailed measurements of superconducting tantalum resonators in order to disentangle sources of loss that limit state-of-the-art tantalum devices. By studying the dependence of loss on temperature, microwave photon number, and device geometry, we quantify materials-related losses and observe that the losses are dominated by several types of saturable two level systems (TLSs), with evidence that both surface and bulk related TLSs contribute to loss. Moreover, we show that surface TLSs can be altered with chemical processing. With four different surface conditions, we quantitatively extract the linear absorption associated with different surface TLS sources. Finally, we quantify the impact of the chemical processing at single photon powers, the relevant conditions for qubit device performance. In this regime we measure resonators with internal quality factors ranging from 5 to 15 x 10^6, comparable to the best qubits reported. In these devices the surface and bulk TLS contributions to loss are comparable, showing that systematic improvements in materials on both fronts will be necessary to improve qubit coherence further.

Over the past decades, superconducting qubits have emerged as one of the leading hardware platforms for realizing a quantum processor. Consequently, researchers have made significant effort to understand the loss channels that limit the coherence times of superconducting qubits. A major source of loss has been attributed to two level systems that are present at the material interfaces. We recently showed that replacing the metal in the capacitor of a transmon with tantalum yields record relaxation and coherence times for superconducting qubits, motivating a detailed study of the tantalum surface. In this work, we study the chemical profile of the surface of tantalum films grown on c-plane sapphire using variable energy X-ray photoelectron spectroscopy (VEXPS). We identify the different oxidation states of tantalum that are present in the native oxide resulting from exposure to air, and we measure their distribution through the depth of the film. Furthermore, we show how the volume and depth distribution of these tantalum oxidation states can be altered by various chemical treatments. By correlating these measurements with detailed measurements of quantum devices, we can improve our understanding of the microscopic device losses.

Neutral silicon vacancy (SiV0) centers in diamond are promising candidates for quantum networks because of their excellent optical properties and long spin coherence times. However, spin-dependent fluorescence in such defects has been elusive due to poor understanding of the excited state fine structure and limited off-resonant spin polarization. Here we report the realization of optically detected magnetic resonance and coherent control of SiV0 centers at cryogenic temperatures, enabled by efficient optical spin polarization via previously unreported higher-lying excited states. We assign these states as bound exciton states using group theory and density functional theory. These bound exciton states enable new control schemes for SiV0 as well as other emerging defect systems.

Neutral silicon vacancy (SiV0) centers in diamond are promising candidates for quantum networks because they feature both excellent optical properties and long spin coherence times. However, spin-dependent fluorescence in such defects has been elusive. In contrast to nitrogen vacancy (NV) centers, the high Debye-Waller factor and correspondingly smaller phonon sideband make off-resonant spin polarization challenging, and optically detected magnetic resonance (ODMR) utilizing the zero phonon line is complicated by limited emission in the phonon sideband and poor understanding of the excited state fine structure. Here we report the realization of ODMR and coherent control of the SiV0 center, enabled by efficient optical spin polarization via higher-lying excited states. We assign these states to be bound exciton states of SiV0 by combining group theory and giant supercell density functional theory (DFT) calculations. These higher-lying states enable efficient optical excitation and spin polarization for SiV0 and provide new possibilities for controlling SiV0 as well as other similar defect systems.

Er ³⁺ ions in crystals are promising for quantum networks. We demonstrate ion implantation of Er ³⁺ into TiO 2 , a potential low-noise host material, with narrow optical and spin linewidths and high implantation yield.

Atomic and atom-like defects in the solid-state are widely explored for quantum computers, networks and sensors. Rare earth ions are an attractive class of atomic defects that feature narrow spin and optical transitions that are isolated from the host crystal, allowing incorporation into a wide range of materials. However, the realization of long electronic spin coherence times is hampered by magnetic noise from abundant nuclear spins in the most widely studied host crystals. Here, we demonstrate that Er3+ ions can be introduced via ion implantation into TiO2, a host crystal that has not been studied extensively for rare earth ions and has a low natural abundance of nuclear spins. We observe efficient incorporation of the implanted Er3+ into the Ti4+ site (> 50% yield), and measure narrow inhomogeneous spin and optical linewidths (20 and 460 MHz, respectively) that are comparable to bulk-doped crystalline hosts for Er3+. This work demonstrates that ion implantation is a viable path to studying rare earth ions in new hosts, and is a significant step towards realizing individually addressed rare earth ions with long spin coherence times for quantum technologies.