Essam Al-Zubaidy’s research while affiliated with American University of Sharjah and other places

The service life of lubricating oil produced in the United Arab Emirates (UAE) was examined using a car fueled with leaded or unleaded gasoline of the same grade in harsh local conditions. In addition, the economic impact of using leaded vs. unleaded gasoline via the effects on the useful life of engine oil was investigated. Every 500 km that the car was operated, the physical properties of the oil were examined to determine the optimum oil life before replacement. It was found that relative to unleaded gasoline, leaded gasoline resulted in a faster deterioration of lube oil properties and a reduced useful life of the oil. Many of the effects of use on the physical properties of oil became apparent from the beginning of its service, especially when leaded gasoline was used. Our findings indicate that the recommended useful life of oil when using leaded gasoline is 2500 km. With unleaded gasoline, deterioration of the physical properties of the lubricating oil became a concern after 3000 km. Thus with unleaded gasoline, it is recommended to have an oil change every 3500 km. These findings indicate that the decision of the UAE government to stop using lead compound additives to improve the octane number of gasoline will not only protect the environment from the harmful effects of lead compounds, but will also extend the useful life of oil. This extension will reduce the amount of used oil that is disposed of by up to 4678 tons/year. This reduction in oil use translates to a cost savings of about 23.4 million UAE Dirhams (=$6.37 million US Dollars) per year.

A solvent extraction process using new hydrocarbon solvents was employed to treat used lubricant oil. The solvents used were liquefied petroleum gas (LPG) condensate and stabilized condensate. A demulsifier was used to enhance the treatment process. The extraction process using stabilized condensate demonstrated characteristics that make it competitive with existing used oil treatment technologies. The process is able to reduce the asphaltene content of the treated lubricating oil to 0.106% (w/w), the ash content to 0.108%, and the carbon residue to 0.315% with very low levels of contaminant metals. The overall yield of oil is 79%. The treated used oil can be recycled as base lubricating oil. The major disadvantage of this work is the high temperature of solvent recovery. Experimental work and results are presented in detail.