ArticlePDF Available

Performance evaluation model for power fluid cooling system of hydraulic excavators

December 2021
Gornyi Zhurnal

DOI:10.17580/gzh.2021.12.12

Authors:

Giang Quốc Khánh

Đại học Công Nghiệp Quảng Ninh

Content uploaded by Giang Quốc Khánh

Content may be subject to copyright.

Journals → Gornyi Zhurnal → 2021 → #12 (https://rudmet.ru/journal/2068/article/34620/)

ArticleName

Performance evaluation model for power fluid cooling system of hydraulic

excavators

DOI

10.17580/gzh.2021.12.12

ArticleAuthor

Giang Quoc Khanh, Krivenko A. E., Pudov E. Yu., Kuzin E. G.

ArticleAuthorData

Quang Ninh University of Industry, Quang Ninh, Vietnam:

Giang Quoc Khanh, Candidate of Engineering Sciences

NUST MISIS, Moscow, Russia:

A. E. Krivenko, Associate Professor, Candidate of Engineering

Sciences, krivenko.ae@misis.ru

Gorbachev Kuzbass State Technical University’s Division in Prokopyevsk, Prokopyevsk,

Russia:

E. Yu. Pudov, Director, Candidate of Engineering Sciences

E. G. Kuzin, Associate Professor

ResearchGate has not been able to resolve any citations for this publication.

ResearchGate has not been able to resolve any references for this publication.

Article

Small capacity absorption systems for cooling and power with a scroll expander and ammonia based wor...

November 2014 · Applied Thermal Engineering

Article

The Eckert number phenomenon: Experimental investigations on the heat transfer from a moving wall in...

May 2004 · Heat and Mass Transfer

Michael Gschwendtner

The Eckert number phenomenon was investigated theoretically by Geropp in 1969 and describes a reversal in heat transfer from a moving wall at an Eckert number Ec ≈ 1. In this report the Eckert number phenomenon is confirmed experimentally for the first time. For that purpose the heat transfer from a heated, vertically rotating cylinder in a crossflow was investigated. In order to perform the ... [Show full abstract] experiments in a range where the predicted phenomenon occurs, extreme rotational speeds were necessary. A heating concept had to be developed which allowed an input of heating power independent of the speed and which therefore had to be contact-free. The results show, among other things, that the temperature difference between the wall and the surrounding fluid has a significant effect on the predicted reversal of heat transfer at the wall. Moreover, maximum heat transfer occurs at an Eckert number Ec ≈ 0.3, which is of great importance for the cooling of hot surfaces in a gas-flow.

Article

Assessment of an ammonia–water power/cooling cogeneration system with adjustable solution concentrat...

November 2013 · Applied Thermal Engineering

Article

Effect of Entrainment Ratio and Subcooling Degree on Dual System of Cooling-Thermal Energy Conversio...

November 2017 · Defect and Diffusion Forum

This study proposes a system called 'dual system of cooling-Thermal energy conversion applying ejector', which practically applies an ejector to an ocean thermal energy conversion (OTEC) system. The proposed system presents higher system efficiency, owing to the application of an ejector, and reduced initial and operating costs. The main results, obtained from simulation analysis, are as follows: ... [Show full abstract] The cooling capacity tended to decrease as the entrainment ratio increased, and the system using R134a generally presented the highest cooling capacity and COP. In terms of generation system, the highest turbine gross power was obtained when the R134a working fluid was applied. The efficiency of the system decreased as the entrainment ratio increased. Finally, the application of the ejector enhanced the efficiency of the generation system, using R134a, by approximately 50%, from 4.73% to 7.10% at the entrainment ratio of 0.1.

Last Updated: 18 Nov 2022