Conference Paper

Comparison among Two-Phase Three-Wire AC Off-Grid Power Systems

Authors:
To read the full-text of this research, you can request a copy directly from the authors.

No full-text available

Request Full-text Paper PDF

To read the full-text of this research,
you can request a copy directly from the authors.

Article
Full-text available
28 June 2018 was the 100th anniversary of the first presentation on symmetrical components made by Charles LeGeyt Fortescue at the 34th Annual Convention of the American Institute of the Electrical Engineers in Atlantic City (NJ, USA). The introduction of the symmetrical component concept was immediately seen as a milestone for electrical system studies, and many applications have been developed during the ensuing years. Today, refined or advanced contributions to conceptual and practical aspects of electrical applications are still being proposed based on the powerful structure of symmetrical components. This paper recalls the most significant steps made in the electrical engineering field after the introduction of the symmetrical component theory, and indicates recent developments concerning the studies on electrical machines, harmonics and interharmonics in different applications, and the operation of power and distribution systems with distributed energy resources.
Conference Paper
Full-text available
This paper presents an analytical method developed to explain the mechanism of harmonic transfer between the ac and dc sides of a single-phase inverter in a PV microgrid. The model explains how the feed-forward of the current from the ac side of the PV-inverter into the control system, causes even harmonics on the dc voltage. It further shows how the controller's feedback of the dc bus voltage carrying even harmonics results in odd harmonics on the ac side of the PV-inverter. This harmonic propagation model is verified with a simulation of the PV microgrid system. The results of this simulation study provides consistency by verifying that odd harmonics on the ac voltage causes even harmonics on the dc bus, and that even harmonics on the dc bus again causes more odd harmonics on ac voltage.
Article
Full-text available
This paper proposes an effective technique to control the power flow among different phases of a three-phase four-wire distribution power system by means of single-phase converters arbitrarily connected among the phases. The aim is to enhance the power quality at the point-of-common-coupling of a microgrid, improve voltage profile through the lines, and reduce the overall distribution losses. The technique is based on a master/slave organization where the distributed single-phase converters act as slave units driven by a centralized master controller. Active, reactive, and unbalance power terms are processed by the master controller and shared proportionally among distributed energy resources to achieve the compensation target at the point-of-common-coupling. The proposed control technique is evaluated in simulation considering the model of a real urban power distribution grid under non-sinusoidal and asymmetrical voltage conditions. The main results, concerning both steady-state and transient conditions, are finally reported and discussed.
Conference Paper
Full-text available
This paper analyzes the harmonic contents of a non-linear load connected to a two-phase microgrid system. Although having the same harmonic content as the single-phase power system when supplying a non-linear load under balanced conditions, the two-phase microgrid system presents the following advantages: 1) constant power through the power line at the balanced condition; 2) two voltages i.e., line-to-line and phase voltages, available by using a three wire system; 3) optimized voltage utilization compared to a three-phase system; and 4) a direct connection of both symmetrical two-phase and single-phase electrical machines. This paper presents an approach for analyzing the harmonics of a two-phase non-linear load in a balanced and unbalanced cases. The mathematical model for the symmetrical component of an unbalanced two-phase system has also been presented in this paper. Finally, a practical implementation of the two-phase system has been performed, where different types of loads are connected to the two-phase power line to test the voltage control performance.
Article
Full-text available
ln recent years, the concept of decentralising power generation through the deployment of distributed generators (DGs) has been widely accepted and applied, driven by the growing market of renewable energy sources. These DGs are normally equipped with a switching power interface, acting as front end with the grid. This paper proposes a multi-task control strategy for distributed generation systems that simultaneously allows the DG to inject the available energy, as well as to work as a voltage drop compensator or as an active power filter, mitigating load current disturbances and improving power quality of the grid. The main contribution of the proposed system, with respect to other solutions in the literature, is that the proposed control loops are based on the Conservative Power Theory decompositions. This choice provides decoupled power and current references for the inverter control, offering a very flexible, selective and powerful control strategy for the DG. The paper also discusses the choice of the current waveform for injecting/absorbing active power into/from the grid, and both sinusoidal and resistive references have been compared in terms of damping capability. Finally, simulation and experimental results are provided in order to validate the proposed functionalities of the DG control system.
Article
Full-text available
With the fast proliferation of single-phase distributed generation (DG) units and loads integrated into residential microgrids, independent power sharing per phase and full use of the energy generated by DGs have become crucial. To address these issues, this paper proposes a hybrid microgrid architecture and its power management strategy. In this microgrid structure, a power sharing unit (PSU), composed of three single-phase back-to-back (SPBTB) converters, is proposed to be installed at the point of common coupling. The aim of the PSU is mainly to realize the power exchange and coordinated control of load power sharing among phases, as well as to allow full utilization of the energy generated by DGs. Meanwhile, the method combining the modified adaptive backstepping-sliding mode control approach and droop control is also proposed to design the SPBTB system controllers. With the application of the proposed PSU and its power management strategy, the loads among different phases can be properly supplied and the energy can be fully utilized, as well as obtaining better load sharing. Simulation and experimental results are provided to demonstrate the validity of the proposed hybrid microgrid structure and control.
Conference Paper
Full-text available
This paper presents a mathematical model for the symmetrical components and power analysis of a new microgrid system consisting of three wires and two voltages in quadrature, which is designated as a two-phase microgrid. The two-phase microgrid presents the following advantages: 1) constant power through the power line at balanced condition; 2) two voltages available by using a three-wire system; 3) optimized voltage utilization compared to a three-phase system; and 4) a direct connection of both symmetrical two-phase and single-phase machines. Unlike the unbalanced three-phase system, which can be represented by three sets of symmetrical components, the unbalanced two-phase system is broken up into only two symmetrical components. Simulation results are employed to demonstrate the feasibility of the theoretical study.
Article
Full-text available
DC-link capacitors are an important part in the majority of power electronic converters which contribute to cost, size and failure rate on a considerable scale. From capacitor users' viewpoint, this paper presents a review on the improvement of reliability of dc link in power electronic converters from two aspects: 1) reliability-oriented dc-link design solutions; 2) conditioning monitoring of dc-link capacitors during operation. Failure mechanisms, failure modes and lifetime models of capacitors suitable for the applications are also discussed as a basis to understand the physics-of-failure. This review serves to provide a clear picture of the state-of-the-art research in this area and to identify the corresponding challenges and future research directions for capacitors and their dc-link applications.
Conference Paper
Full-text available
A new concept of microgrid is proposed in this paper, which is based on power systems with two voltages in quadrature. The two-phase microgrid system described in this paper has the following advantages: 1) constant power at balanced condition; 2) two voltages available by using a three-wire system; 3) optimized voltage utilization compared to a three-phase system; and 4) a direct connection of both symmetrical two-phase and single-phase machines. This paper describes the power analysis as well as an advanced converter interfacing the two-phase microgrid and a conventional single-phase utility grid. Experimental results validate the theoretical expectations.
Article
Unbalanced voltage sags are common phenomenon in power systems which affects the performance of grid-connected photovoltaic (PV) systems. The unbalanced voltage conditions results in double-line frequency power oscillations. These oscillations increase the dc-link voltage ripple leading to higher stresses in dc-link capacitors. In this case, the literature presents many power control strategies in order to improve the performance of PV systems during unbalanced conditions. Nevertheless, a deep comparison of these strategies has been missing. This work presents a complete analysis of the main power control strategies proposed in the literature. The energy storage requirements of the converter are analytically deduced and some guidelines for the dc-link design are presented. Furthermore, a case study based on a 11 kW PV system is used to compare the performance of the most interesting strategies in terms of dynamic behaviour, power oscillations and dc-link voltage ripple. Furthermore, the dc-link capacitors stress is discussed, considering the characteristics of reactive power injection , which is required by the modern grid codes. The power losses and the thermal stresses in dc-link capacitors are evaluated and the worst operational scenario is obtained for each power control strategy.
Article
The Conservative Power Theory (CPT) is a time-domain theory applicable to any periodic signal, single- or poli-phase system with or without neutral conductor. The principle operation is the orthogonal decomposition of electrical variables, resulting electrical quantities with physical meaning. An important feature of the CPT is the current decomposition. It consists of decomposing any current into five parts. The label of these parts are active current, reactive current, scattered active current, scattered reactive current and generated current. This paper proposes the application of the current decomposition of the CPT in Distributed Energy Resources (DERs). A Supervisory Controller (SC) uses the current decomposition in a load power sharing strategy. The combination of these two issues is the main contribution of this paper. Moreover, the proposal of this paper is more attractive than the conventional droop strategy since the DERs follow their current reference in a current-controlled mode, making the load sharing faster, more reliable and more accurate. A clear understanding of how the CPT decomposes load currents into its parts is presented as well as the drawback found in droop strategy when dealing with load power sharing. Later, the SC load power sharing strategy is described, indicating that the proposal of this paper makes a SC to have a broad option when managing a smartgrid with dispatchable DERs. A case study with experimental results show the efficacy of applying current decomposition of the CPT in load power sharing strategies.
Conference Paper
Capacitors have been witnessed as one of the weak points in grid-connected PhotoVoltaic (PV) applications, and thus efforts have been devoted to the design of reliable DC-link capacitors in PV applications. Since the hot-spot temperature of the capacitor is one of the failure inducers, instantaneous thermal modeling approaches considering mission profiles for the DC-link capacitor in single-phase PV systems are explored in this paper. These thermal modelling approaches are based on: a) fast Fourier transform, b) look-up tables, and c) ripple current reconstruction. Moreover, the thermal modelling approaches for the DC-link capacitors take into account the instantaneous thermal characteristics, which are more challenging to the capacitor reliability during operation. Such instantaneous thermal modeling approaches enable a translation of instantaneous capacitor power losses to capacitor thermal loading from the operating conditions. As a consequence, it offers new insights into the temperature monitoring and reliability-oriented design of the DC-link capacitors, and thus a more reliable operation of single-phase grid-connected PV systems can be enhanced. Study results on a 3-kW single-phase grid-connected PV system have been adopted to demonstrate a look-up table based modelling approach, where real-field daily ambient conditions are considered.
Article
Smart microgrids offer a new challenging domain for power theories and metering techniques because they include a variety of intermittent power sources which positively impact on power flow and distribution losses but may cause voltage asymmetry and frequency variation. In smart microgrids, the voltage distortion and asymmetry in presence of poly-phase nonlinear loads can be also greater than in usual distribution lines fed by the utility, thus affecting measurement accuracy and possibly causing tripping of protections. In such a context, a reconsideration of power theories is required since they form the basis for supply and load characterization. A revision of revenue metering techniques is also suggested to ensure a correct penalization of the loads for their responsibility in generating reactive power, voltage asymmetry, and distortion. This paper shows that the conservative power theory provides a suitable background to cope with smart grids characterization and metering needs. Simulation and experimental results show the properties of the proposed approach.
Article
Smart microgrids offer a new challenging domain for power theories and compensation techniques, because they include a variety of intermittent power sources, which can have dynamic impact on power flow, voltage regulation, and distribution losses. When operating in the islanded mode, low-voltage smart microgrids can also exhibit considerable variation of amplitude and frequency of the voltage supplied to the loads, thus affecting power quality and network stability. Due to limited power capability in smart microgrids, the voltage distortion can also get worse, affecting measurement accuracy, and possibly causing tripping of protections. In such context, a reconsideration of power theories is required, since they form the basis for supply and load characterization, and accountability. A revision of control techniques for harmonic and reactive compensators is also required, because they operate in a strongly interconnected environment and must perform cooperatively to face system dynamics, ensure power quality, and limit distribution losses. This paper shows that the conservative power theory provides a suitable background to cope with smart microgrids characterization needs, and a platform for the development of cooperative control techniques for distributed switching power processors and static reactive compensators.
Conference Paper
This paper proposes a grid-interfacing power quality compensator for three-phase three-wire microgrid applications with consideration of both the power quality of the microgrid and the quality of currents flowing between the microgrid and utility system. It is proposed that two inverters (a shunt and a series) are used for each distributed generation (DG) system in the microgrid. For each inverter, both positive-and negative-sequence components are controlled to compensate for the effects caused by the unbalanced utility grid voltages. Specifically, the shunt inverter is controlled to ensure balanced voltages within the microgrid and to regulate power dispatches among parallel-connected DG systems, while the series inverter balances the line currents by injecting appropriate voltage components. A current-limiting algorithm is also proposed and integrated within the inverter control schemes to protect the microgrid from large fault currents during utility voltage sags (balanced or unbalanced). The proposed compensator has been tested in simulations and experimentally using a laboratory hardware prototype.