Available via license: CC BY-NC-SA 4.0
Content may be subject to copyright.
VOLUME 7 NO. 1, FEBRUARI 2011
1 Architect of Saevfor Consulting, Sweden 37
USED TIRE AS BASE ISOLATOR TIRE
FOR EARTHQUAKE RESISTANT HOUSES
Inggemar Särfors1
ABSTRACT
The investigation of foundation on tires for absorbing the earthquake energy on houses structure is
described here. The foundations are cut cone in shape. There are two tests have been conducted to
investigate the shaking energy absorption. First, the foundation is placed on the sand filled tire. The
second one, the double tires support round foundation. For comparison purpose, the foundation on
sand test without tire is also conducted. The laboratory tests are performed using double hydraulic
jack to generate the applied loads. The first jack is used to give the vertical load on the top of
foundation to simulate the house load. The other jack is used to produce the load in the horizontal
direction to replicate the earthquake load. The results of the tests are plotted in the terms of
horizontal load and displacement corves. The double tires foundation shows the higher horizontal
displacement-load ratio compared to the others. It indicates that the double tire based foundation
absorbing the earthquake energy better than the others. It is concluded that the tired based
foundation can be installed to support in the earthquake resistant houses.
Keywords: foundation, earthquake resistance, base isolation
1. BACKGROUND
The Andalas University has played a major lead role in the damage assessments and reconstruction
guidelines after the West Sumatra earth quake in September 2009. Many research focused on
behaviour of dynamic resistant of the ordinary houses has been initiated. To strengthen the future
research, recently a dedicated Seismic Research Center in the Civil Engineering department has
been established.
In this university, the shake table (2m x 3m) mimics the horizontal ground acceleration of an earth
quake and sensor devices send records of the movements to a computer have been set up. Beside
the dynamic load test, horizontal push over tests on a structure or an element of structure also have
been conducted. In the future, the tests of dynamic loading of tire-base-foundations are conducted
using the shake table.
When a big earth quake attaches a house, many possibilities can happen. It the house strong enough
to the earthquake, then nothing happen and loss of human lives can be avoided. But if the house is
in very bad condition as many houses in the earth, it can be broken or some of material waste could
be felt down and be dangerous to the human under it.
In many countries such as Japan and USA with top of the line seismic mitigation technology, there
are sophisticated isolator devices in the foundations that provide this preventive protection from the
earthquake attach. Roller bearings on bowl-shaped steel dishes or neoprene rubber cushions
separate the violent shock waves in the ground from the building foundations. Needless to say these
technologies are too expensive for the majority of potential earth quake victims in the world,
especially for ordinary people.
Used Tire As Base Isolator Tire
For Earthquake Resistant Houses
38 | JURNAL REKAYASA SIPIL
Fortunately, in developing countries similar principles could be expanded using local materials
with alternative design approaches. However, up to now not much attention has been devoted to
such solutions by the international development community. Apart from the earth quake risk
reduction achieved at a much lower cost there could also be considerable employment
opportunities generated for unskilled people.
After the earth quake in West Sumatra, September 2009, the idea came to mind to use old car and
motor cycle tires as shock absorbers. It turned out that these waste products do not have any
particular value, not even in the informal sector (Figure 1). Being mainly an environmental health
problem as mosquito breeding deposits a synergy effect could then be achieved if used as
construction materials in the foundations. Another advantage would be the reduction of fire risks,
once ignited rubber fires are extremely difficult to fight.
Figure 1. Disposal of Used Tires (by Saevfors, 2010)
2. ELEPHANT FOOT ON A TIRE
In order to take advantage of old tires as shock absorbers, a step in the ongoing research on low
cost seismic base isolators for house foundations has been initiated in cooperation with Andalas
University. The idea was to test a single unit of the “elephant foot on a tire” concept with a vertical
load (about 2 ton for a real house) to represent the proportional weight of a brick house. (For more
background details, see files available at www.saevfors.se).
The use of tires as shock absorbers is based on the practical experiences as follow:
a. In many harbors there are old tires hanging on the quay sides as fenders to reduce the shock
when a ship hits the dockside.
b. In car races, piles of tires are used for spectators to protect against crashing vehicles.
c. When blasting rocks in open air, mat assemblies of cut tires are used to protect against
undesired destruction effects.
Previously Luleå Technical University (LTU) in Sweden, has already a solid knowledge of
recycling rubber waste, mainly in the form of shredded tire mixed with soil aggregates. This
technology is mainly used for road banks in Sweden. Hence the environmental consequences of
Inggemar Särfors
VOLUME 7 NO. 1, FEBRUARI 2011 | 39
long term underground use of tire rubber are already well known. Luckily the pollution risks for
ground water etc. are negligible.
The hardening, cracking and final defragmentation of tires visible on vehicle churchyards are
primarily due to the ultraviolet radiation from the sun. This process could be totally avoided if the
tires are buried in a foundation trench. Even it has not been investigated yet, base on the experience
that the buried rubber under the ground still can endure for years. Other development and research
made in this field focus also on mixing rubber particles with soil. Some of these concepts are
targeting foundations of large buildings.
In construction, however, the direct use of tires, as they are, is an idea apparently not yet explored.
One reason could be the presumed stability issues and the potential problems of cracking walls
associated with a moving foundation on flexible rubber. However these issues could also be
addressed in an alternative design allowing for dilatation joints for example. These are after all
secondary problems of merely esthetics compared to the massive devastation of an earth quake.
Then the stability of ‘one piece’ house on a shaking must be the final target of the many steps
research on Earthquake Resistant Houses on Used Tires (Figure 2).
Here, the proposal of “Elephant foot on a tire”, is designed to be integrated with the brick
construction practice in Indonesia. The earthquake norms prescribe a robust configuration of
reinforced concrete columns and beams to confine the brickwork and make the house to jolt as one
unit.
The prefabricated “Elephant feet” on tires could be merged into this system when the foundation
beam is cast. The convex bottom face allows the “Foot” to center back to the car tire after each
bump. The concept is based on locally available materials, simple tools and mainly unskilled labor.
Local masons and craftsmen could be trained for supervision.
Figure 2. A house on tire-base-feet
3. TESTS
The preliminary design of the test of tire-base-foundation system is designed to observe the
maximum force (both vertical and horizontal forces, and the combination of them) that can be
supported by the system (Figure 3). The tire-base-foot is placed on the sand filled box. The
thickness of the sand is 10 cm.
Used Tire As Base Isolator Tire
For Earthquake Resistant Houses
40 | JURNAL REKAYASA SIPIL
V
H
V
Figure 3. Tire-base-foot on sand (by Saevfors, 2010)
First, the applied vertical force is given by the use of hydraulic jack. The load is applied slowly
and the vertical compression (settlement) of the tire is monitored. The applied load is topped when
the tire is completely flat and the vertical force is referred as the maximum one (Figure 4).
Figure 4. Vertical and push over test of the foot
Then, under the maximum vertical force, the horizontal force are slowly applied. The horizontal
displacement during the loading is recorded. The collapse of the tire-base-foot system is considered
if the movement (horizontal displacement) of the system is propagated by the slip of the contact
surface between the tire and the sand. The same way (push over test) is adopted to the double-tire
and no-tire base foundation. The force-displacement graph of horizontal force each test can be
sketched from the tests.
4. RESULTS
4.1 Vertical Loading
The test results of vertical force shows in Table 1. The vertical compression (settlement) on the
tires for single tire resulting about a third of that doubles one. For single tire, the flat tire occurred
with the maximum force of 2000 kg. The double tire system gave more settlement that is about
a. Initial b. Final a. Initial b. Final
Inggemar Särfors
VOLUME 7 NO. 1, FEBRUARI 2011 | 41
twice of single tire one but the maximum vertical force just only 700 kg. The test result for single
and double tire with vertical load shows that the more tire used as foundation base, the less vertical
bearing capacity resulted.
Table 1. Maximum Vertical Load
Base type Maximum Vertical load
Single-tire 2000 kg
Double-tires 700
4.2 Horizontal Push Over
The first push over test applied to the single-tire base foundation is shown in Figure 5. The applied
horizontal linearly increases till it reach the force of 600 kg. Beyond this point, the displacement of
the foundation happened on the tire-foundation system. After this point, the sliding on the contact
surface between the tire and sand initially occurred. The sliding surface keeps on going as the
horizontal force is continuously applied that indicates the slip failure has occurred.
V=2000 kg (1-tire)
0
200
400
600
800
1000
0 5 10 15 20 25 30
Disp. (mm)
H (kg)
Figure 5. Push Over Test of The Single-Tire Foot
The push over test result for double tire with vertical load of 700 kg is shown in Figure 3. The test
gives different result to the previous one. In the beginning of the push over test, it shows non-linear
behavior in term of horizontal-displacement curve. The slip failure on the contact surface between
the tire and sand happened about 300 kg of horizontal force, that is less than a half of single-tire
one. However, the displacement on the tires is about three times compared to the single-tire. It
indicates the advantage of the use of the tire to dissipate the horizontal energy. The push over
energy is converted to the displacement without any failure on the foundation. In case of isolated
foundation, the tire can role as the absorbed energy (Figure 6.)
Used Tire As Base Isolator Tire
For Earthquake Resistant Houses
42 | JURNAL REKAYASA SIPIL
V=700 kg (2-tires)
0
50
100
150
200
250
300
350
0 5 10 15 20 25 30
Disp. (mm)
H (kg)
Figure 6. Push Over Test of The Double-Tire Foot
The last of this series test is the push over of elephant foot on sand. The foot is placed on sand
directly without any tire, then vertical load are jacked. The vertical load is given only 2000 kg to
see the behavior of the foot without tire. Then the horizontal force is pushed on the top of footing in
the same way as previous tests. The test result for this type of foundation is shown in Figure 7. The
horizontal load – displacement curve has a peak before it goes to its residual strength (slip). This
behavior is very different to the results test of feet on tires. The important thing recognized from
this result is that the slip on contact surface between footing and the sand happens as soon as the
horizontal force is applied. The maximum displacement at the final push over force is about 10
mm.
V=2000 kg (No-tires)
0
100
200
300
400
500
600
700
800
0 5 10 15 20 25 30
Disp. (mm)
H (kg)
Figure 7. Push Over Test of Foot on Sand
Figure 8. shows the plot all tests of the foundation models in the same graph. Clearly understood
that the bigger vertical load given, the higher maximum horizontal force is formed. It shows that
there is a relation between vertical load on footing and its horizontal resistance.
Inggemar Särfors
VOLUME 7 NO. 1, FEBRUARI 2011 | 43
H .vs. Disp
0
100
200
300
400
500
600
700
800
900
0 5 10 15 20 25 30
Dis p. ( mm )
H (kg)
700
No- tire
2000
Figure 8. Push Over Test of Elephant Feet
The normalization horizontal forces compared to the maximum load applied to each model is
shown in the Figure 9. First, it can be seen that the horizontal force-load curves from feet on tire
(single and double) have low slope compare. It may happen due to the effect of the rubber tire
under the foundation. The second point is that for 2000 kg foot on tires has push over strength
higher than the food on sand. It may indicate that the tire contribute to the sliding strength of the
feet. The sliding strength in contact surface sand-rubber is higher compared to the sand-footing
(concrete).
5. OBSERVATIONS
Base on this initial test of footing on tire base as the absorbed earthquake energy for houses, there
are some points can be drawn:
a. The quality of the used tires may play a major role. The initial tests in Sweden to check the
general rubber resistance to compression, it can be provided the winter specification tires at
hand. Although used and deemed to be no longer suitable for cars, these were obviously of
much higher quality than regular worn out Indonesian tires. For the next test phase a selection
from a good number of used tires would certainly make a difference in performance as the
there is a considerable variation in quality of tires in Indonesia. Even the better used tires still
have economic values.
b. Even so, with the low quality of these random tire samples, the displacement at an earth
quake corresponding to a 0.5 G acceleration, would allow for an important dissipation of the
shock wave energy. Hence the searched shock absorber effect is achieved.
c. The comparatively higher displacement of the tires without sand filling is here an advantage
if we consider the ground moving under the building. The displacement allowed by the rubber
material reduces the shock movements transferred to the building more significantly.
d. The reason for applying two layer tires in test was again the low quality of the samples. One
tire alone would probably not have sustained the weight and would have caused a touchdown
of the elephant foot, thus spoiling the isolator effect.
Next steps to be done to complete the research on shake absorber in used of tire are:
a. An enlarged test phase to have a statistically more solid basis.
b. Prequalification of used tire samples prior to tests. The large quantities available would
prevent a negative price effect.
Used Tire As Base Isolator Tire
For Earthquake Resistant Houses
44 | JURNAL REKAYASA SIPIL
c. Shake table tests of a 4 unit, self stabilized Elephant foot configuration.
d. Test of the “Rolling stones effect”, as initially designed. Round river stones under the
elephant foot could work as roller bearings in the bottom of the foundation (Figure 9.)
e. Building of demo prototype houses.
Figure 9. Rolling Stones Effect of Footing
REFERENCES
Ingemar Saevfors, (2010)a, “Seismic Shock Absorbers From Used Tires”, 21-29 May 2010,
http://www.saevfors.se.
Ingemar Saevfors, (2010)b, “Tests on Seismic shock absorbers from used tires: Draft Version”,
August 27, 2010.
http://www.youtube.com/watch?v=EFdO3kcMe_4
