PreprintPDF Available

Evaluation of noise limits of a precision ADC for direct digital signal integration of magnetic measurements

Authors:
  • Enron Research and G-Tronic Robotics
Preprints and early-stage research may not have been peer reviewed yet.

Abstract and Figures

The characterization of laboratory plasma instabilities, magnetic reconnection and turbulence associated phenomena, require the simultaneous signal sampling from arrays of magnetic sensors (hundreds or even thousands) to obtain spatial resolution, with several hundred kHz for time resolution. Magnetic measurements based on pick-up (Mirnov) coil are quite common in experimental pulsed devices for plasma research, thanks to their simplicity and reliability. Being the signal from this type of sensor proportional to the time variation of the magnetic field (dB/dt), it has to be time-integrated to recover the instant value of magnetic field. Depending on the required integration time usually either analog integrators or chopped integrators are used. However these solutions tend to limit the frequency bandwidth in the kHz range, they are not easy to design and build, and require additional fast channels to directly acquire the dB/dt signal to recover the plasma dynamic features at higher frequencies. In this paper we evaluate the feasibility of using a direct single channel precision ADC to allow the simultaneous acquisition of dB/dt measurements and to provide the integrated B measurement by means of digital integration on the new RFX-mod2 device. On this purpose we interfaced an existing ADC-module to a Xilinx Zynq FPGA, in order to evaluate the intrinsic noise and to investigate the feasible integration window of this configuration. The result opens the door to a compact, cost-effective and reliable acquisition system, usable for simultaneous real-time control and transient signal recording, scalable from tenths to thousands channels, applicable to a broad class of pulsed plasma experimental devices.
Content may be subject to copyright.
A preview of the PDF is not available
ResearchGate has not been able to resolve any citations for this publication.
Article
The tokamak scrape-off layer (SOL) plasma dynamics is investigated in a circular limiter configuration with a low edge safety factor. Focusing on the experimental parameters of two ohmic tokamak inner-wall limited plasma discharges in RFX-mod [Sonato et al., Fusion Eng. Des. 74, 97 (2005)], nonlinear SOL plasma simulations are performed with the GBS code [Ricci et al., Plasma Phys. Controlled Fusion 54, 124047 (2012)]. The numerical results are compared with the experimental measurements, assessing the reliability of the GBS model in describing the RFX-mod SOL plasma dynamics. It is found that the simulations are able to quantitatively reproduce the RFX-mod experimental measurements of the electron plasma density, electron temperature, and ion saturation current density (jsat) equilibrium profiles. Moreover, there are indications that the turbulent transport is driven by the same instability in the simulations and in the experiment, with coherent structures having similar statistical properties. On the other hand, it is found that the simulation results are not able to correctly reproduce the floating potential equilibrium profile and the jsat fluctuation level. It is likely that these discrepancies are, at least in part, related to simulating only the tokamak SOL region, without including the plasma dynamics inside the last close flux surface, and to the limits of applicability of the drift approximation. The turbulence drive is then identified from the nonlinear simulations and with the linear theory. It results that the inertial drift wave is the instability driving most of the turbulent transport in the considered discharges.
Article
The fast-slow-fast rotation frequency transitions of tearing modes under magnetic feedback boundary conditions have been studied in some recent RFX-mod experiments performed at low current, with tearing mode amplitudes close to the wall-locking threshold. The avoidance of strict wall-locked conditions for amplitudes above the threshold thanks to the feedback-induced slow rotations is a well-established result of RFX-mod. The present experiments, well reproduced by simulations performed with a validated MHD model, demonstrate another benefit of the feedback: the possibility of recovering the fast rotation with no hysteresis when reducing the amplitude. This evidence changes the standard paradigm valid in the absence of feedback, which considers the transition from fast rotation to wall-locked condition a substantially irreversible process.
Article
RFX is the largest magnetic confinement fusion machine operating with the reversed field pinch (RFP) configuration. The RFX magnetic measurement system has been completely redesigned in order to meet the electromagnetic, mechanical and thermal requirements of the new toroidal assembly, with the thinner shell and the new system of coils for MHD modes control. In total, 744 independent measurements are available, 712 probes are placed in between the vacuum vessel and the new thin shell, where an air gap of only 6mm thickness is available. Temperature can rise up to 200°C and a voltage up to 2000V can develop between shell and vessel during machine operation. To comply with such extreme requirements, specific techniques were developed for probes and connections.Conditioning electronics have been completely redesigned to improve accuracy and interferences immunity. Integrator drifts were lowered by an order of magnitude with respect to the previous system, and a new front-end was designed to cope with extended signal bandwidths and the presence of high frequency noise due to new powerful switching power supplies. Mechanical characteristics of conditioning channels were changed to improve modularity and reliability.This paper describes the design of all integral probes the tools and procedures adopted for installation and tests of the whole probe system, and the design and realisation of the conditioning electronics.
Article
A new system of internal magnetic coils is being implemented in the Reversed Field eXperiment Reversed Field Pinch (RFP). The global layout of the system has to take into account the peculiar characteristics of RFP plasmas and the integration with other internal and external measurements. The design of probes measuring fluctuations of different magnetic field components is described stressing how the requirements of thermal and electrical insulations are met. In particular, due to the large number of signals needed and to the limited space available inside the vessel, original solutions to minimize probe and cable dimensions were adopted. Thermal and electrical tests on prototypes were performed allowing, in addition, the validation of a numerical model for the study of the signal bandwidth. © 2003 American Institute of Physics.
Article
The IST/EURATOM Association is developing a new generation of control and data acquisition hardware for fusion experiments based on the ATCA architecture. This emerging open standard offers a significantly higher data throughput over a reliable High Availability (HA) mechanical and electrical platform. One of this ATCA boards has 32 galvanically isolated ADC channels (18 bit) each mounted on a swappable plug-in card, 8 DAC channels (16 bit), 8 digital I/O channels and embeds a high performance XILINX Virtex 4 family field programmable gate array (FPGA). The specific modular and configurable hardware design enables adaptable utilization of the board in dissimilar applications. The first configuration, specially developed for tokamak plasma Vertical Stabilization, consists of a Multiple-Input-Multiple-Output (MIMO) controller that is capable of feedback loops faster than 1 ms using a multitude of input signals fed from different boards communicating through the Aurora™ point-to-point protocol. Massive parallel algorithms can be implemented on the FPGA either with programmed digital logic, using a HDL hardware description language, or within its internal silicon PowerPC™ running a full fledged real-time operating system. The second board configuration is dedicated for transient recording of the entire 32 channels at 2 MSamples/s to the on-board 512 MB DDR2 memory. Signal data retrieval is accelerated by a DMA-driven PCI Express™ x1 Interface to the ATCA system controller, providing an overall throughput in excess of 100 MB/s. This paper illustrates these developments and discusses possible configurations for foreseen applications.
  • P Sonato
  • G Chitarin
  • P Zaccaria
  • F Gnesotto
  • S Ortolani
  • A Buffa
  • M Bagatin
  • W Baker
  • S D Bello
  • P Fiorentin
  • L Grando
  • G Marchiori
  • D Marcuzzi
  • A Masiello
  • S Peruzzo
  • N Pomaro
  • G Serianni
P. Sonato, G. Chitarin, P. Zaccaria, F. Gnesotto, S. Ortolani, A. Buffa, M. Bagatin, W. Baker, S. D. Bello, P. Fiorentin, L. Grando, G. Marchiori, D. Marcuzzi, A. Masiello, S. Peruzzo, N. Pomaro, and G. Serianni, Fusion Engineering and Design 66-68, 161 (2003), 22nd Symposium on Fusion Technology.
  • S Peruzzo
  • M Bernardi
  • R Cavazzana
  • S D Bello
  • M D Palma
  • L Grando
  • E Perin
  • R Piovan
  • A Rizzolo
  • F Rossetto
  • D Ruaro
  • M Siragusa
  • P Sonato
  • L Trevisan
S. Peruzzo, M. Bernardi, R. Cavazzana, S. D. Bello, M. D. Palma, L. Grando, E. Perin, R. Piovan, A. Rizzolo, F. Rossetto, D. Ruaro, M. Siragusa, P. Sonato, and L. Trevisan, Fusion Engineering and Design, (2018).
  • G Marchiori
  • R Cavazzana
  • P Bettini
  • L Grando
  • S Peruzzo
G. Marchiori, R. Cavazzana, P. Bettini, L. Grando, and S. Peruzzo, Fusion Engineering and Design 123, 892 (2017), proceedings of the 29th Symposium on Fusion Technology (SOFT-29)
  • G Manduchi
  • A Barbalace
  • A Luchetta
  • A Soppelsa
  • C Taliercio
  • E Zampiva
G. Manduchi, A. Barbalace, A. Luchetta, A. Soppelsa, C. Taliercio, and E. Zampiva, Fusion Engineering and Design 87, 1907 (2012).
  • M Zuin
  • N Vianello
  • M Spolaore
  • V Antoni
  • T Bolzonella
  • R Cavazzana
  • E Martines
  • G Serianni
  • D Terranova
M. Zuin, N. Vianello, M. Spolaore, V. Antoni, T. Bolzonella, R. Cavazzana, E. Martines, G. Serianni, and D. Terranova, Plasma Physics and Controlled Fusion 51, 035012 (2009).