Article

Expanding metabolism for biosynthesis of nonnatural alcohols. Proc Natl Acad Sci USA

Department of Chemical and Biomolecular Engineering and Chemistry, University of California, Los Angeles, CA 90095, USA.
Proceedings of the National Academy of Sciences (Impact Factor: 9.67). 01/2009; 105(52):20653-8. DOI: 10.1073/pnas.0807157106
Source: PubMed

ABSTRACT

Nature uses a limited set of metabolites to perform all of the biochemical reactions. To increase the metabolic capabilities of biological systems, we have expanded the natural metabolic network, using a nonnatural metabolic engineering approach. The branched-chain amino acid pathways are extended to produce abiotic longer chain keto acids and alcohols by engineering the chain elongation activity of 2-isopropylmalate synthase and altering the substrate specificity of downstream enzymes through rational protein design. When introduced into Escherichia coli, this nonnatural biosynthetic pathway produces various long-chain alcohols with carbon number ranging from 5 to 8. In particular, we demonstrate the feasibility of this approach by optimizing the biosynthesis of the 6-carbon alcohol, (S)-3-methyl-1-pentanol. This work demonstrates an approach to build artificial metabolism beyond the natural metabolic network. Nonnatural metabolites such as long chain alcohols are now included in the metabolite family of living systems.

Download full-text

Full-text

Available from: Michael R Sawaya, Jun 23, 2014
    • "and biosynthesis from glucose [35]. It should be noted that production of both these higher alcohols consumes lesser energy due to their longer carbon chains when compared to other lower alcohols [33]. "
    [Show abstract] [Hide abstract]
    ABSTRACT: This study attempts to achieve simultaneous reduction of smoke and NOx emissions using a combination of low EGR, retarded injection timing and diesel fuel reformulation (with low cetane number alcohols) to enable a partially premixed low temperature combustion (LTC) mode in DI diesel engine. Two higher alcohol/diesel blends, B40 (40% iso-butanol - 60% diesel) and P40 (40% n-pentanol - 60% diesel blends) were prepared and tested under the combination of three EGR rates (10%, 20% and 30%) and two injection timings (23° and 21° CA bTDC) at high loads and constant engine speed. The performance and emission characteristics of the engine under these conditions are investigated. Results indicate that B40 gives a longer ignition delay, higher peak pressure and higher premixed heat release rate than P40. B40 has superior EGR tolerance and better influence on NOx-smoke trade-off when compared to P40. At retarded injection timing (21 CA bTDC) and 30% EGR, B40 presented simultaneous reduction of NOx (41.7%) and smoke (90.8%) emissions with diesel-like performance while P40 presented simultaneous reduction of NOx (32.6%) and smoke (92.3%) emissions with a small drop in performance. It was found that B40 presented better smoke suppression characteristics than P40. Smoke emissions of both blends increased drastically beyond 30% EGR. HC emissions increased and CO emissions remained low for both blends at all EGR rates. The combination of low EGR, late injection and higher alcohol/diesel blends can achieve partially premixed LTC and reduce smoke and NOx emissions simultaneously.
    No preview · Article · Dec 2015 · Fuel
    • "n-Pentanol is a 5-carbon straight-chain alcohol that is recently gathering attention because of its advantages over other butanol isomers[33]. It is an excellent biofuel that can be produced from biological pathways like natural microbial fermentation of[35]. It should be noted that production of both these higher alcohols consumes lesser energy due to their longer carbon chains when compared to other lower alcohols[33]. "
    [Show abstract] [Hide abstract]
    ABSTRACT: Iso-butanol is a second generation biofuel that has the potential to improve energy security and mitigate harmful pollutants in reciprocating engines. The present study investigates the effect of iso-butanol addition to diesel fuel on performance and emissions of a single cylinder direct-injection diesel engine with exhaust gas recirculation (EGR). For this objective, four iso-butanol/diesel blends containing 10%, 20%, 30% and 40% were prepared by volume basis and tested in the engine under three EGR rates: 10 to 30% (at increments of 10%) with the combination of two injection timings: 23° and 21° crank angle (CA) before top dead centre (bTDC). Experimental results showed that the combination of 30% EGR rate, 40% iso-butanol addition (ISB40) and retarded injection timing by 2 CA bTDC simultaneously reduced NOx emissions from 1284 to 749ppm and smoke opacity from 20.7 to 1.9% with a slight drop in performance. It was found that higher iso-butanol/diesel blends require higher EGR levels to attain optimum levels of smoke and NOx emissions. Both hydrocarbon (HC) and carbon-monoxide (CO) emissions presented an increasing trend at escalating EGR rates. At retarded injection timing, ISB40 blend presented decreased HC emissions, increased CO emissions with slight drop in performance compared to its injection at original timing.
    No preview · Article · Nov 2015 · Proceedings of the Institution of Mechanical Engineers Part A Journal of Power and Energy
    • "L-leucine is mainly assimilated through the L-leucine catabolic pathway (Fig. 1), which has a significant biological and biotechnological importance , marked by the biodegradation of recalcitrant compounds (Lahme et al. 2012; Schuster et al. 2012; Hyman 2013) and the generation of intermediates for synthesizing metabolites with wide-range applications in medical, food, bioplastic and biofuel industries (Fig. 2) (Yan and Liao 2009; Ziadi et al. 2010; Saika et al. 2014; Vogt et al. 2015). The intermediates aketoisocaproic acid and isovalery-CoA, generated during the L-leucine catabolism, are of special interest as they are precursors of a wide range of compounds; they can be channeled to alternate routes of secondary metabolism to produce compounds with biotechnological applications (Zhang et al. 2008; Smit et al. 2009). The a-ketoisocaproic acid is a regulation factor in metabolism which has been used in the therapy for treating chronic kidney disease patients (Zhu et al. 2011; Vogt et al. 2015), whereas in food and fuel industries it is a precursor of flavor compounds and biofuels, respectively (Ziadi et al. 2010; Sinz and Schwab 2012). "
    [Show abstract] [Hide abstract]
    ABSTRACT: l-Leucine can be assimilated by bacteria when sugars or other preferential carbon sources in the habitat are depleted. The l-leucine catabolism is widely spread among bacteria and has been thoroughly studied. Its pathway is comprised by multiple reactions and converges with other catabolic routes, generating acetoacetate and acetyl-CoA as its final products. The initial three steps are conserved in most bacteria, constituting the first steps of the branched-chain amino acids catabolic pathway. The main product of these sequential reactions is the 3-methylcrotonyl-CoA metabolite, which undergoes further enzymatic steps towards the production of acetoacetate and acetyl-CoA. These, however, are not always the final products of l-leucine catabolism, as intermediates of the pathway can further synthesize fatty acids or feed other secondary metabolism pathways in order to produce diverse compounds which can exhibit biological activities. This alternative metabolism typically leads to the accumulation of products bearing industrial relevance, including volatile compounds used in the food industry, compounds with antimicrobial activity, production of biofuels and biopolymers. In anaerobic bacteria, the l-leucine catabolism may induce the accumulation of a variety of organic compounds acids, such as isovaleric, isocaproic, and 2-methylbutyric acids. In conclusion, the usage by bacterial species of l-leucine as an alternative carbon and nitrogen source may contribute to their environment adaptability and, more importantly, the diverse products that can be obtained from l-leucine metabolism may be represent a valuable source of compounds of biotechnological interest.
    No preview · Article · Oct 2015 · Reviews in Environmental Science and Bio/Technology
Show more