
Sarah Addyani Binti ShamsuddinUniversiti Teknologi Mara (Pulau Pinang) · FACULTY OF ELECTRICAL ENGINEERING
Sarah Addyani Binti Shamsuddin
About
5
Publications
855
Reads
How we measure 'reads'
A 'read' is counted each time someone views a publication summary (such as the title, abstract, and list of authors), clicks on a figure, or views or downloads the full-text. Learn more
17
Citations
Citations since 2017
Introduction
Skills and Expertise
Publications
Publications (5)
This paper presents a power electronic devices application focus on modeling, analysis, and control of switching power converter in the inverting DC substation with regenerative braking system which is used to recycle the surplus regenerative power by feed it back to the main AC grid. The main objective of this research is to improve the switching...
Previously, many researches had been done on non-invasive using near-infrared sensing. Sia had investigated near-infrared sensing using signal penetrating finger method. However, by using finger penetration, there are no results obtained. He only obtained signal using glucose concentration. Therefore the objectives of this research are to investiga...
This project uses a non-invasive method for measuring the blood glucose concentration levels. By implementing two infrared light with different wavelength; 940nm and 950nm based on the use of light emitting diodes and measure transmittance through solution of distilled water and d-glucose of concentration from 0mg/dL to 200mg/dL by using a 1000nm p...
This work has focused on the design simulation analysis of a Polysilicon-based CMOS micromachined Piezoresistive Microcantilever beam for glucose sensing application. In principle, adsorption of glucose on a functionalized surface of the microfabricated cantilever will cause a surface stress and consequently the cantilever bending. In this paper, t...
This research have been done in order to know the effect of mechanic characteristics to the microactuator such as microcantilever beam deflection. From there, we also observed the effect of voltage and initial condition to the microcantilever displacement and the transient response characteristics. In this research, we used the analytical method an...