Panagiota Giannakopoulou

• PhD Geologist
• University of Patras

This study deals with the preliminary characterization of sterile materials and by-products in order to be used in geopolymer syntheses for environmental applications. Specifically, the new low cost syntheses of geopolymers, will be used as filters in waste water treatment. The utilization of alternative raw materials can contribute significantly n...

Especially in recent years, the study of landslide phenomena is considered as very important because of the effects of climate change. The aim of this paper is to examine the stability of the slope located in Miacher Nagar village along the Hunza River (HR), using the Limit Equilibrium Method (LEM). The Miacher slope rises to a height of 900 m from...

Clays have been applied for centuries by people for many uses. From pottery to medicine, clays and clay minerals constitute part of individuals’ daily routines. Natural fine-grained earth material, commonly found at Xi beach coastal area of Lixouri in Kefalonia island, was used during the last few decades by local people as well as from tourists fo...

Research attempts on biomass use constitute a response to the growing demand for sustainable and low-cost energy from renewable sources. Hence, the sustainable use of Posidonia oceanica (PO) waste as a material for biomass to produce green energy is being considered in many countries in the Mediterranean region. PO meadows are considered as the mai...

Various types of plutonic and volcanic rocks and their alteration products from Greece (serpentinite, magnesite and andesite), have been used for sustainable removal of Uranium (U) from the acidic drainage of Kirki mine, as well as for the pH increase of the polluted solutions. In this light, this study aims at the further understanding and improve...

Carbon dioxide (CO2) has reached a higher level of emissions in the last decades, and as it is widely known, CO2 is responsible for numerous environmental problems, such as climate change. Thus, there is a great need for the application of CO2 capture and storage, as well as of CO2 utilization technologies (CCUS). This review article focuses on sum...

In this paper the results of an experimental study on the behaviour of aggregate shape on the compressive concrete strength was described. The main scope of that work is to answer whether there is a low-cost, low-energy methodology for predicting the behavior of an aggregate within a concrete and therefore its ultimate strength. This was achieved b...

This study was based on the reduction of the extraction of natural resources and, at the same time, was focused on the use of by-products and various wastes in construction applications by following the principles of circular economy. Sterile natural rocks (limestones, basalts), industrial by-products (slags), hotel construction wastes (bathroom wa...

This study focuses on the use of petrology as a useful tool in construction applications (i.e., concrete). More specifically, this study investigates how the petrogenetic characteristics of ultramafic rocks derived from ophiolite complexes (Veria–Naousa, Gerania) can act as a key tool for the prediction of the final behaviour of ultramafic aggregat...

X-ray micro-computed tomography (μCT) was applied upon selected ophiolitic rock samples from various localities of the Vardar ophiolite outcrops in North Greece. Effectiveness of the μCT application was evaluated through this case study by comparing results with other state-of-the-art techniques (e.g., optical microscopy, mineral chemistry microana...

The scope of this study focuses on the use of two different types of industrial byproducts such as slags (FeNi and Electric Arc Furnace slag) combined with natural sand as concrete aggregates as well as the evaluation of their suitability on the final physicomechanical behavior of the produced concrete specimens. For this reason, twelve concrete sp...

In the Veria-Naousa ophiolitic complex (north Greece), rodingite appears mainly in the form of cross cutting dykes within serpentinised peridotites. It is distinguished into three types, based upon the provenance of its protoliths, textural characteristics, mineralogical assemblages and geochemical affinities. Type I rodigites were derived from bon...

The need for environmentally friendly construction materials is growing more and more these days. This paper investigates byproducts from Greece, such as magnesite tailings from Evoia and fly ash from Kardia (Ptolemais), in order to evaluate their suitability as cement additives. For this purpose, the raw materials were tested and studied regarding...

The sustainable use of agricultural, industrial and human waste products as raw materials in the construction industry has been extensively investigated. This study aimed to conceive an innovative concrete composition mainly using recycled materials, which, as a result as waste from human activities and natural organic growth, such as animal bones...

Featured Application Τhe smelting process can be applied for the direct recycling of the nickel ferrous dust collected in the gas cleaning systems of the rotary kilns (R/Ks) during the pre-reduction of laterite ore in the course of ferronickel production by the pyrometallurgical route. The method can also be applied for smelting of ore fines. Conta...

Dear Colleagues, We invite contribution to this special issue of Minerals (Impact Factor 2.250). Looking forward to receive your new innovative submissions. click here for more information: https://www.mdpi.com/journal/minerals/special_issues/APCM The Guest Editors,

We investigate with this study the effectiveness of mechanically activated serpentinite in capturing Cu (II) from the multi-constituent acidic wastewater of the pit lakes of the Agios Philippos mine (Greece), proposing specific areas with serpentinites suitable for such environmental applications. For this purpose ultramafic rock samples that are c...

This study examines how the chemical composition of ultramafic and mafic rocks effects their physicomechanical properties and therefore how influences the concrete strength of the produced concrete specimens. For this scope, ultramafic (Group I) and mafic rocks (Group II) derived from the Veria–Naousa and Edessa ophiolite complexes (Greece) were se...

The presence or the absence of swelling clay minerals in rocks, which are used in various construction applications, constitutes a determinant factor for their strength, and consequently, in their general behavior in various construction applications, as they have the ability to swell up to 400 times of their usual volume, causing failures to any a...

This study investigates how the petrographic features of Klepa Nafpaktias sandstones affect their behavior in construction applications such as concrete, in environmental applications such as energy storage as well as whether they are suitable for the above uses. For achieving this goal, sandstones (ten samples) were collected in order to study the...

In this study obsidian samples from “Nychia” area of Milos Island (Greece) have been analyzed and characterized with various analytical techniques including polarizing microscopy, XRPD, SEM/EDS, ICP-MS and Raman Spectroscopy. The studied samples have a rhyolitic composition. Microliths (feldspars, silica oxide phases, hornblende, biotite and opaque...

This paper examined three different types of recycled materials, such as beer green glass, waste tile, and asphalt, which will be used in different mixtures in order to prepare concrete specimens and, more specifically, their effect on concrete strength and how the petrographic characteristics of various recycled materials influenced the durability...

This paper investigates an alternative use of sterile aggregate materials which may arise from various construction applications in conjunction with other low-cost mineral raw materials to remediate the acid mine drainage phenomenon. This study is based on the combination of unprocessed mineral raw materials, as well as on the basic concept of the...

This paper investigates an alternative use of sterile aggregate materials which may arise from various construction applications in conjunction with other low-cost mineral raw materials to remediate the acid mine drainage phenomenon. This study is based on the combination of unprocessed mineral raw materials as well as on the basic concept of the c...

The Edessa ophiolite complex of northern Greece consists of remnants of oceanic lithosphere emplaced during the Upper Jurassic-Lower Cretaceous onto the Palaeozoic-Mesozoic continental margin of Eurasia. This study presents new data on mineral compositions of mantle peridotites from this ophiolite, especially serpentinised harzburgite and minor lhe...

This paper investigates the interrelationships between the engineering properties of igneous aggregate rocks from Greece with the aid of the R-mode factor analysis. The collected samples represent mafic and ultramafic rocks from the ophiolite complexes of Gerania, Guevgueli, Veria-Naousa, and Edessa as well as intermediate-acidic rocks from the sur...

This paper examines the effect of the aggregate type on concrete strength, and more specifically, how the petrographic characteristics of various aggregate rocks as well as their physico-mechanical properties influences the durability of C 25/30 strength class concrete. The studied aggregate rocks were derived from Veria-Naousa and Edessa ophioliti...

This paper examines the effect of the aggregate type on concrete strength and more specifically how the petrographic characteristics of various aggregate rocks as well as their physico-mechanical properties influences the durability of C 25/30 strength class concrete. The studied aggregate rocks are derived from Veria-Naousa and Edessa ophiolitic c...

This paper investigates the effect of alteration on the physicomechanical properties of igneous rocks used as aggregates, from various areas from Greece. The studied lithologies include serpentinized dunites, serpentinized harzburgites, serpentinized lherzolites, metamorphic gabbros, diabases, dacites and andesites. Quantitative petrographic analys...

This case study investigates the influence of the mineralogical composition of ultramafic rocks derived from two ophiolite complexes from Greece (Veria-Naousa and Gerania) on their mechanical, physical and physicochemical properties. The investigated lithologies include lherzolite, harzburgite, dunite and olivine-orthopyroxenite with variable degre...

This paper investigates the effect of alteration on the physicomechanical properties of igneous rocks from various areas from Greece used as aggregates. The studied lithologies include dunites, harzburgites, lherzolites, gabbros, diabases, dacites and andesites. Quantitative petrographic analysis shows that the tested samples display various percen...

This study aims at the interpretation of the adverse effects of the secondary products in two types of rocks during their performance as concrete aggregates. Serpentinised peridotites contain serpentine, as the dominant secondary phase, which creates low microroughness on the particles and therefore unfavorable surfaces for cement paste to adequate...

This study presents the combined use of field mapping, remote sensing data analysis, mineralogy, spectroscopy and GIS techniques for the geological mapping of Antiparos Island. Antiparos is part of the Cyclades Blueschist Belt located in central Aegean, where gneisses, schists and Pliocene volcanic rocks occurred. During the extended field work, a...

Ultramafic rocks from the Gerania Mountain ophiolite were tested as aggregates. Petrographic study through polarizing microscope enabled us to determine the presence of dunite, harzburgite and lherzolite. A series of mechanical tests were carried out in order to determine the suitability of these rocks in a wide range of applications. Dunite and ha...