Henri Boessenkool

Dutch Institute for Fundamental Energy Research · Remote Handling

Tele-manipulation of heavy loads typically requires the simultaneous use of two asymmetric slaves: a crane for vertical weight support; and a robot for accurate lateral positioning. The industrial standard prescribes a pair of operators for such tasks (one operator to control each slave), although in principle one operator might control both slaves...

For the planned teleoperated maintenance of the experimental fusion plant ITER the time performance will be critical. Telemanipulated task execution is however characterised by long execution times compared to similar tasks performed hands-on. There is little quantitative research on task performance of telemanipulated maintenance available to give...

Telemanipulation techniques allow for human-in-the-loop assembly and maintenance tasks in otherwise inaccessible environments. Although it comes with limitations in achieved performance - required strict operator selection and extensive training are widely encountered - there is very little quantitative insight in the exact problems operators encou...

Haptic shared control can improve execution of teleoperation and driving tasks. However, shared control designs may suffer from conflicts between individual human operators and constant haptic assistance when their desired trajectories differ, leading to momentarily increased forces, discomfort or even deteriorated performance. This study investiga...

Unexpected events during maintenance operations of a fusion plant like JET or ITER may require rescheduling, suspending the execution of the current procedure to pick it up later. In this paper, we look at how the introduction of slack influences the port plug maintenance schedule robustness. We introduce a metrics to measure the robustness. Simula...

Remote maintenance will determine the available uptime of future fusion plants such as ITER. Experience at predecessor JET showed that a human-in-the-loop tele-operated approach is crucial, although this approach entails drawbacks such as the unavoidable extensive operator training and relatively long execution times. These drawbacks are common kno...

One of the challenges in future fusion plants such as ITER is the remote maintenance of the plant. Foreseen human-in-the-loop tele-operation is characterized by limited visual and haptic feedback from the environment, which results in degraded task performance and increased operator workload. For improved tele-operated task performance it is requir...

A promising solution to improve task performance in ITER hot cell remote handling is the use of haptic shared control. Haptic shared control can assist the human operator along a safe and optimal path with continuous guiding forces from an intelligent autonomous controller. Previous research tested such controllers with accurate knowledge of the en...

Haptic shared control is a promising approach to increase the effectiveness of remote handling operations. While in haptic shared control the operator is continuously guided with assistive forces, the operator's response to forces is not fully understood. This study describes the development of a computational model of a human operator controlling...

In teleoperation, haptic feedback allows the human operator to touch the remote environment. Yet, it is only partially understood to what extent the quality of haptic feedback contributes to human-in-the-loop task performance. This paper presents a human factors experiment in which teleoperated task performance and control effort are assessed for a...

Telemanipulation allows human to perform operations in a remote environment, but performance and required time of tasks is negatively influenced when (haptic) feedback is limited. Improvement of transparency (reflected forces) is an important focus in literature, but despite significant progress, it is still imperfect, with many unresolved issues....

Virtual Reality (VR) simulation can be used to study, improve and verify ITER maintenance operations during preparation. VR can also improve the situational awareness of human operators during actual Remote Handling (RH) operations. Until now, VR systems use geometric models of the environment and the objects being handled and kinematic models of t...

In tele-operation, haptic feedback from the remote environment to the human is often limited, which has been shown to negatively influence the performance and required time of tasks. The conventional research focus is on improving the quality of the haptic feedback (transparency), which may have led to significant improvement, but is still imperfec...