• Home
  • Aws Hashim Al-Jrew
Aws Hashim Al-Jrew

Aws Hashim Al-Jrew
Al-Muthanna University · College of Engineering / Electronics and communication eng. dept.

PhD candidate in Electrical Engineering

About

2
Publications
252
Reads
How we measure 'reads'
A 'read' is counted each time someone views a publication summary (such as the title, abstract, and list of authors), clicks on a figure, or views or downloads the full-text. Learn more
1
Citation
Introduction
I am researcher on Renewable Energy , working as lecturer at Ministry of higher education and Scientific research .specially on solar and wind energy. I work now on my PhD thesis dealing with multilevel inverter for induction heating system . I will be happy to share the knowledge with others . Regards
Additional affiliations
December 2017 - present
Al-Muthanna University
Position
  • Lecturer
Education
November 2009 - January 2012
Universiti Tenaga Nasional (UNITEN)
Field of study
  • Electrical Power Engineering
October 2001 - July 2005
Al-Mustansiriya University
Field of study
  • Electrical Engineering

Publications

Publications (2)
Article
Full-text available
In this article, a comparison of innovative multilevel inverter topology with standard topologies has been conducted. The proposed single phase five level inverter topology has been used for induction heating system. This suggested design generates five voltage levels with a fewer number of power switches. This reduction in number of switches decre...
Thesis
This dissertation demonstrates the maximum power point tracking methods which became an important part of any PV array system in order to extract maximum power from the PV system because of the high cost of PV system. The conventional perturb and observe MPPT method is the most common MPPT method and widely used to compare with the other new MPPT m...

Questions

Question (1)
Question
I want to ask about the design done by ansys maxwell then i made the thermal coupling ( thermal transient ) using machanical ansys ...the material of piece is changed from copper to structural steel ...how can I avoid this?
And how can I add the frequency and current using mechanical ansys as shown in picture below?

Network

Cited By