Question
Asked 14 May 2017
can EEG be built with arduino as a controller?
Hello. I am trying to build an EEG device is it possible to build it with arduino & what to use for electrodes and amplification
can anyone provide me a rough circuit design
thanks
Most recent answer
can you help me find bio-emf-fingerprint signature? i need it for a psychotronic jamming device so the sender will land in a honeypot and not me like with a radar jammer. the world thanks you!
1 Recommendation
All Answers (9)
Yes, you can but it has its own limitations. You haven't specified exactly what you want your arduino to do!!
Electrodes - you can use a normal gold plated disc electrodes and signal conditioning can be done before the actual signal goes into your controller via ADC. Amplification can be done inside the controller, again it depends on the application and as I said before what you want your controller to do.
1 Recommendation
Hi Hamza,
Have a look on my paper: "BITalino: A Multimodal Platform for Physiological Computing". I don't specify any EEG circuit but you can have a look on the ECG or EMG circuits to get inspiration for your own designs. It's the same principle of measurement - potential difference.
BITalino is an Arduino inspired board for electrophysiological recording signals.
Best,
Jose
2 Recommendations
Singidunum University
Check out these two projects for EEGs based on the Arduino platform:
1 Recommendation
University of Plymouth
Check Here, https://www.olimex.com
At the moment i'm using a EMG Shield and it work!
MEGIN
You can explore : http://openeeg.sourceforge.net/doc/index.html
Related Publications
Nowadays technology enables using of small devices to control complex systems. These devices (microcontrollers) can provide enough performance to substitute personal computers (PC). The two most known microcontrollers (Arduino and Raspberry) are connected together to one system. The article provides insight into the issue of inputs and outputs and...
In this article, we will develop a system that allows the monitoring of hydrants through an Arduino microcontroller in the city of Managua. Which will consist of 3 stages. A Stage of Sensors and Actuators, Communication Stage and Server Configuration. Which can be monitored from a subdomain of the Firebase platform.
This paper shows how very simple circuitry attached to an Arduino microcontroller with MakerPlot software can be used for the display of electrical characteristic curves of three commonly available devices: an ohmic resistor, an LED, and a tungsten-filament bulb.