Figure - available from: Semiconductor Science and Technology
This content is subject to copyright. Terms and conditions apply.
Source publication
In 3D NAND, as the stack number increases, the process cost becomes higher and higher, and the stress problem becomes more and more serious. Therefore, the low cost and low stress plasma enhanced tetraethyl orthosilicate (PE TEOS), compared to high density plasma (HDP) oxide, shows its superiority as pre-metal dielectric (PMD) oxide layer in 3D NAN...
Similar publications
Bulk micromachining in silicon is governed by the etching process where anisotropic (wet) etching in KOH can yield complex structures beyond that achievable with isotropic (dry) etching techniques. One example is the miniaturised frame reported herein with an area of 2.9 to 7.5 mm2, walls that are 1/10 mm thick, a height of 525 µm equipped with slo...
Single LiNbO3 (LNO) crystals are widely utilized in surface acoustic wave devices, optoelectronic devices, and novel ferroelectric memory devices due to their remarkable electro-optic and piezoelectric properties, and high saturation and remnant polarizations. However, challenges remain regarding their nanofabrication that hinder their applications...
The impact of the post-trench restoration on the electrical characteristics of vertical GaN power devices is systematically investigated in this work. Following the achievement of microtrench-free GaN trench structure with modified dry etching conditions, the post-trench tetramethylammonium hydroxide (TMAH)-based wet etching and UV/Ozone-based oxid...
Patterning of NiO/Ga2O3 heterojunctions requires development of selective wet and dry etch processes. Solutions of 1:4 HNO3:H2O exhibited measurable etch rates for NiO above 40°C and activation energy for wet etching of 172.9 kJ.mol-1 (41.3 kCal.mol-1, 1.8 eV/atom), which is firmly in the reaction-limited regime. The selectivity over β-Ga2O3 was in...
Nanolithography with self‐assembled block copolymers (BCPs) is an emerging competitive alternative to conventional lithography, which is currently reaching its limits with regard to resolution and economic feasibility. For high‐resolution lithography, both the abruptness of BCP internal interfaces between self‐assembled polymer nanodomains and the...
