Figure 2 - uploaded by Zakia Afroz
Content may be subject to copyright.
2.2: The Brush windmill (the first use of a large windmill to generate electricity.) in Cleveland, Ohio, 1888.
Source publication
The present research work concerns with the dynamic conditions of Multi-bladed rotor at different Reynolds number. The investigation on wind loading and aerodynamic effects on the four, five and six bladed S-shaped vertical axis vane type rotor have been conducted with the help of a subsonic wind tunnel together with the experiment set-up of the va...
Similar publications
The flow-field in the vicinity of tandem building model in a wind tunnel will be subjected to analysis of dynamics. The model is 3D consisting of the two blocks of different sizes arranged in a streamwise direction. Experiments were performed using time-resolved PIV technique in several measuring planes to capture both spatial and dynamical feature...
At present experimental gas-dynamic studies of supersonic flows mainly use complex experimental facilities, such as aerodynamic wind tunnels and shock tubes. However, in order to study supersonic flows with Mach numbers M < 4, a vacuum wind tunnel (which is much simpler) can also be used. This paper is concerned with starting processes occurring in...
This paper presents the overall pros and cons of the effect of surface roughness elements over a NACA 4412 tapered, swept back half wing with a sweep angle of 30º and a dihedral angle of 5º. The tests were conducted at a Reynolds number of 4 × 105 in the IIUM Low Speed wind tunnel. Different roughness sizes and roughness locations were tested for a...
The results of studies of heat fluxes that can occur in the gas supersonic flow created in the wind tunnel with a magnetogasdynamic accelerator are presented. For two operation modes of the installation, measurements of heat fluxes to the surface of a calorimetric model were performed. The dependences of these parameters on induction of magnetic fi...
The effects of a forced flow on spread rate and mass burning rates of flames over solid fuels have been investigated for several decades, but experimental works connecting the two problems are very limited. In this work, we consider the variations of fuel thickness and flow velocity and analyze their effect on the two parameters. Slabs of Polymethy...
