Figure 7 - Non-oxide precipitates in additively manufactured austenitic stainless steel

Temperature v/s time curves obtained from the heat transfer FE simulation of LMD of the 3-layer wall of Fig. 1b at the locations X, Y and Z. The temperature rates shown inside the plot have units K/s. Superscript 'c' implies cooling and 'h' implies heating. The rates in red, blue and green font correspond to the rates encountered by points X, Y and Z, respectively, during LMD. The subscripts 'min' and 'max' to the temperature rates correspond to minimum and maximum, respectively, rates for a given curve. EQ solidus stands for the equilibrium solidus temperature. T !"# $%& is the minimum temperature below

Go to figure page

Reference

Non-oxide precipitates in additively manufactured austenitic stainless steel - Scientific Figure on ResearchGate. Available from: https://www.researchgate.net/figure/Temperature-v-s-time-curves-obtained-from-the-heat-transfer-FE-simulation-of-LMD-of-the_fig4_351575891 [accessed 27 Mar, 2023]

Caption

Figure 7: Temperature v/s time curves obtained from the heat transfer FE simulation of LMD of the 3-layer wall of Fig. 1b at the locations X, Y and Z. The temperature rates shown inside the plot have units K/s. Superscript 'c' implies cooling and 'h' implies heating. The rates in red, blue and green font correspond to the rates encountered by points X, Y and Z, respectively, during LMD. The subscripts 'min' and 'max' to the temperature rates correspond to minimum and maximum, respectively, rates for a given curve. EQ solidus stands for the equilibrium solidus temperature. T !"# $%& is the minimum temperature below

Embed code

<a href="https://www.researchgate.net/figure/Temperature-v-s-time-curves-obtained-from-the-heat-transfer-FE-simulation-of-LMD-of-the_fig4_351575891"><img src="https://www.researchgate.net/profile/Manas-Upadhyay/publication/351575891/figure/fig4/AS:1023208773939200@1620963390122/Temperature-v-s-time-curves-obtained-from-the-heat-transfer-FE-simulation-of-LMD-of-the.png" alt="Temperature v/s time curves obtained from the heat transfer FE simulation of LMD of the 3-layer wall of Fig. 1b at the locations X, Y and Z. The temperature rates shown inside the plot have units K/s. Superscript 'c' implies cooling and 'h' implies heating. The rates in red, blue and green font correspond to the rates encountered by points X, Y and Z, respectively, during LMD. The subscripts 'min' and 'max' to the temperature rates correspond to minimum and maximum, respectively, rates for a given curve. EQ solidus stands for the equilibrium solidus temperature. T !"# $%& is the minimum temperature below"/></a>