Figure - uploaded by Amar Al-jzari
Content may be subject to copyright.


Source publication
Conference Paper
Full-text available
This paper presents results of path loss measurements, in two indoor environments for both LoS and NLoS scenarios across a frequency range from 0.6-73 GHz using the multi-band custom designed channel sounders developed at Durham University. The data are analysed to estimate the path loss parameters for each frequency band with either the close in p...

Context in source publication

Context 1
... tables indicate that generally the value of σ is smaller for the FI model than the CI model which indicates a better fit. The ABG model parameters are summarized in Table 3 for the two environments. For the LoS case, the frequency and distance parameters are close to the free space value of 2. For the NLoS case, the corridor distance coefficient exhibited a higher value than the office environment due to the wall blockage leading to higher losses. ...


... The conventional procedure for calibration is to disconnect the antennas from the channel sounder and to calibrate the RF front ends between the antenna ports and the antennas separately. 1 To calibrate the front ends, a full two-port calibration is prescribed for vector network analyzer (VNA)-based systems [8], [13], [16]; other correlation-based systems employ a back-to-back method [9]- [12], [15]. These calibration procedures have been well established for years and so are relatively standard and straightforward, yet some do not calibrate the front ends at all [4]- [7]. 1. ...
... And to enable precision antenna de-embedding, it is spherical angle (AZ and EL) that must be estimated, yet only a few papers do [9]- [11], [16] -the others either estimate AZ only [12], [13] or no angle at all. Finally, although an antenna may be classified as omnidirectional [15], antenna gain is never truly omnidirectional in both planes and so its effects on estimated path gain cannot be ignored. ...
... In any case, when different channel sounders are deployed by different organizations to record measurements [14], a meaningful comparison across bands is difficult to obtain since specific calibration procedures will vary from organization to organization. This is true even when different channel sounders are used by the same organization [4]- [8], [15] since calibration is never perfect. The comparison is more meaningful when the same organization uses the same channel sounder across all bands, albeit with different antennas [9]- [12]. ...
Full-text available
Millimeter-wave (mmWave) communications promise Gigabit/s data rates thanks to the availability of large swaths of bandwidth between 10–100 GHz. Although cellular operators prefer the lower portions of the spectrum due to popular belief that propagation there is more favorable, the measurement campaigns to confirm this – conducted by ten organizations thus far – report conflicting results. Yet it is not clear whether the conflict can be attributed to the channel itself – measured in different environments and at different center frequencies – or to the differences in the organizations’ channel sounders and sounding techniques. In this paper, we propose a methodology to measure mmWave frequency dependence, using the 26.5–40 GHz band as an example. The methodology emphasizes calibration of the equipment so that the measurement results represent the channel alone (and not the channel coupled with the channel sounder). Our results confirm that free-space propagation is indeed frequency invariant – a well understood phenomena but to our knowledge reported nowhere else at mmWave to date. More interestingly, we found that specular paths – the strongest after the line-of-sight path and so pivotal to maintaining connectivity during blockage – are the least invariant compared to weaker diffracted and diffuse paths.