Flow chart of the fabrication process of Nb2O5 thin films

Contexts in source publication

Context 1

... rpm for 30 s and immediately sintered at 150 ℃ for 15 min in the hot plate to promote the rapid evaporation of the solvent and the removal the organic residuals. After that, the samples were divided into the pieces. Finally, while the samples were annealed at 300, 400, 500 and 600˚C600˚C, for 1 h by conventional thermal annealing (CTA) system. Fig. 1 shows schematically the work flow of the Nb2O5 thin films. ...

Context 2

... greater than n of the diode, and I(V) is current value obtained from I-V plot. F(V)-V curve should have coordinates of a minimum point which is determined the Rs and ΦB as follows: where Imin is the value of the forward-bias current corresponding to Vmin, F (Vmin) and Vmin are the coordinates of minimum point and the F(V)-V plot is given in Fig. 10. In consequence of the Norde function, the B and Rs values of the Al/Nb2O5 SBD are presented in Table 2. The Rs, derived from Norde's and Cheung method, does not have same values. This mismatch arises from the fact that the Norde method applies to the ideal diode and applies to the fully forward bias I-V characteristics of the device ...