Figure 4 - uploaded by Dominik Hering
Content may be subject to copyright.
Connectors of the HP model, where ˙ m fl,evap is the mass flow rate, that enters the evaporator with a temperature of T fl,evap , ˙ mre,evap leaves the evaporator with a temperature of Tre,evap, ˙ m fl,cond enters the condenser with a temperature of T fl,cond and ˙ m re,cond leaves the condenser with a temperature of T re,cond .
Contexts in source publication
Context 1
... optimize the operation of each HP in the network. The HP model contains formulations for operational behavior of the HP and it is shown in Figure 4. The HP model has the connectors of Fig. 4. First, the incoming thermal power, ˙ Q evap,t , and outgoing thermal power, ˙ Q cond,t , are calculated according to ...
Context 2
... optimization model contains components of the pipe network and the consumers and is based on previous work [27]. We optimize the operation of each HP in the network. The HP model contains formulations for operational behavior of the HP and it is shown in Figure 4. The HP model has the connectors of Fig. 4. First, the incoming thermal power, ˙ Q evap,t , and outgoing thermal power, ˙ Q cond,t , are calculated according ...
Similar publications
In order to stabilize the output fluctuation of wind power generation, this paper applies control strategy to control the action of the battery energy storage system according to the stability target, and quickly makes up for the system demand. In this paper, the optimal scheduling of new energy power system with energy storage is studied. This mod...
Developing model predictive control (MPC) schemes can be challenging for systems where an accurate model is not available, or too costly to develop. With the increasing availability of data and tools to treat them, learning-based MPC has of late attracted wide attention. It has recently been shown that adapting not only the MPC model, but also its...
Approximate dynamic programming (ADP) faces challenges in dealing with constraints in control problems. Model predictive control (MPC) is, in comparison, well-known for its accommodation of constraints and stability guarantees, although its computation is sometimes prohibitive. This paper introduces an approach combining the two methodologies to ov...
