Publications (2)7.17 Total impact
-
Article: Experimental demonstrations of record high REAM intensity modulator-enabled 19.25Gb/s real-time end-to-end dual-band optical OFDM colorless transmissions over 25km SSMF IMDD systems.
[show abstract] [hide abstract]
ABSTRACT: Record-high 19.25Gb/s real-time end-to-end dual-band optical OFDM (OOFDM) colorless transmissions across the entire C-band are experimentally demonstrated, for the first time, in reflective electro-absorption modulator (REAM)-based 25km standard SMF systems using intensity modulation and direct detection. Adaptively modulated baseband (0-2GHz) and passband (6.125 ± 2GHz) OFDM RF sub-bands, supporting signal line rates of 9.75Gb/s and 9.5Gb/s respectively, are independently generated and detected with FPGA-based DSP clocked at only 100MHz as well as DACs/ADCs operating at sampling speeds as low as 4GS/s. The two OFDM sub-bands are electrically multiplexed for intensity modulation of a single optical carrier by an 8GHz REAM. The REAM colorlessness is experimentally characterized, based on which optimum REAM operating conditions are identified. To maximize and balance the signal transmission performance of each sub-band, on-line adaptive transceiver optimization functions and live performance monitoring are fully exploited to optimize key OOFDM transceiver and system parameters. For different wavelengths within the C-band, corresponding minimum received optical powers at the FEC limit vary in a range of <0.5dB and bit error rate performances for both baseband and passband signals are almost identical. Furthermore, detailed investigations are also undertaken of the maximum aggregated signal line rate sensitivity to electrical sub-band power variation. It is shown that the aforementioned system has approximately 3dB tolerance to RF sub-band power variation.Optics Express 04/2013; 21(7):9167-79. · 3.59 Impact Factor -
Article: Retrieving quasi-phase-matching structure with discrete layer-peeling method.
[show abstract] [hide abstract]
ABSTRACT: An approach to reconstruct a quasi-phase-matching grating by using a discrete layer-peeling algorithm is presented. Experimentally measured output spectra of Šolc-type filters, based on uniform and chirped QPM structures, are used in the discrete layer-peeling algorithm. The reconstructed QPM structures are in agreement with the exact structures used in the experiment and the method is verified to be accurate and efficient in quality inspection on quasi-phase-matching grating.Optics Express 07/2012; 20(14):15826-32. · 3.59 Impact Factor