Publications (2)0.73 Total impact
-
Article: Carbon spheres prepared via solvent-thermal reaction method and their microstructures after high temperature treatment
[show abstract] [hide abstract]
ABSTRACT: Carbon spheres with size of 50–300 nm were synthesized via a solvent-thermal reaction with calcium carbide and chloroform as reactants in a sealed autoclave. The morphologies and microstructures of carbon spheres before and after high temperature treatment (HTT) were characterized by X-ray diffractometry (XRD), scanning electronic microscopy (SEM), energy diffraction spectroscopy (EDS), and transmission electron microscopy (TEM). The formation mechanism of carbon spheres was discussed. The results indicate that the carbon spheres convert to hollow polyhedron through HTT. Carbon spheres are composed of entangled and curve graphitic layers with short range order similar to cotton structure, and carbon polyhedron with dimension of 50–250 nm and shell thickness of 15–30 nm. The change of solid spheres to hollow polyhedron with branches gives a new evidence for formation mechanism of hollow carbon spheres. Key wordscarbon spheres-solvent-thermal method-microstructure-high temperature treatmentJournal of Central South University of Technology 05/2012; 17(5):895-898. · 0.36 Impact Factor -
Article: Wet friction performance of C/C-SiC composites prepared by new processing route
[show abstract] [hide abstract]
ABSTRACT: C/C-SiC composites with SiC island distribution were prepared via a new processing route. The fabrication process mainly included silicon infiltration by ultrasonic vibration, chemical vapor deposition (CVD), siliconizing, liquid phase impregnation and carbonization. The wear and friction properties were tested by an MM-1000 wet friction machine. The results show that SiC phases are mainly distributed between carbon fibers and pyrocarbons as well as among the pryocarbons. The dynamic friction coefficient of the composites decreases gradually from 0.126 to 0.088 with the increase of the surface pressure from 0.5 to 2.5 MPa at the same rotary speed. Furthermore, under the constant surface pressure, the dynamic friction coefficient increases from 0.114 to 0.126 with the increase of the rotary speed from 1 500 to 2 500 r/min. However, the coefficient decreases to 0.104 when the rotary speed exceeds 4 500 r/min. During the friction process, the friction coefficient of C/C-SiC composite is between 0.088 and 0.126, and the wear value is zero after 300 times brake testing.Journal of Central South University of Technology 04/2012; 16(4):525-529. · 0.36 Impact Factor
