Publications (2)9.6 Total impact
-
Article: Irrigation, Organic Matter Addition, and Tarping As Methods of Reducing Emissions of Methyl Iodide from Agricultural Soil.
[show abstract] [hide abstract]
ABSTRACT: Methyl iodide (MeI) is increasingly being used as a highly effective alternative to the soil fumigant methyl bromide. Due to its volatile and toxic nature, MeI draws wide attention on its potential atmospheric emission following field fumigation treatment. Using soil columns that make it possible to determine emissions and gas phase distribution of soil fumigants, we studied MeI behavior in two soils differing in organic matter content. Additionally, the effectiveness of surface irrigation and tarping with virtually impermeable film (VIF) was assessed. In the lower organic matter, bare soil (control), emissions of MeI were rapid and high (83% of total). Although the peak emission flux was reduced by irrigation, the total loss was very similar to the control (82%). Tarping with VIF dramatically reduced emissions (0.04% total emissions). In the higher organic matter soil, degradation rate of MeI was increased around 4-fold, leading to a significant reduction in emissions (63% total emissions). The work suggests that surface tarping with VIF would be highly effective as an emissions reduction strategy and would also result in the maintenance of high soil gas concentrations (important for pest control). Ripping of the tarp after two weeks led to an immediate spike release of MeI, but, even so, the flux rate at this time was almost 20 times lower than the peak flux rate in the control. Even with tarp ripping, the total emission loss from the VIF treatment remained low (6%).Environmental Science & Technology 01/2011; · 4.80 Impact Factor -
Article: 1,3-dichloropropene and chloropicrin emissions following simulated drip irrigation to raised beds under plastic films.
[show abstract] [hide abstract]
ABSTRACT: Using laboratory soil chambers a nonscaled representation of an agricultural raised bed was constructed. For a sandy loam soil, 1,3-dichloropropene (1,3-D) and chloropicrin (CP) were applied at 5 cm depth with an excess of water (simulated drip irrigation). Application was made under both high density polyethylene (HDPE) and virtually impermeable film (VIF) covering the soil bed (the furrow was left uncovered). Soil gas distribution of the fumigants, together with emissions into the headspace above the bed, sidewall and furrow were determined over time. Total emissions from the HDPE treatment were cis 1,3-D 28%, trans 1,3-D 24%, and CP 8%. Due to its lower permeability, the values for VIF were 13%, 7%, and 1.5%, respectively. With HDPE, the majority (86-93%) of the emissions occurred from the bed, while for VIF the majority (92-99%) of the emissions was from the furrow. Compared to a range of literature values for shank injection, the use of drip application appears to offer a benefit in reducing 1,3-D and CP emissions. However, the most meaningful comparison is with our previous data for simulated shank injection where the same soil was covered (completely) with the same plastic films (1). In this comparison, only 1,3-D emissions under HDPE were lower with drip application; 1,3-D emissions under VIF and CP emissions under both films were greater with the drip application.Environmental Science & Technology 08/2010; 44(15):5793-8. · 4.80 Impact Factor
