-
[show abstract]
[hide abstract]
ABSTRACT: An accurate and precise method for the determination of arsenobetaine (AsB, (CH(3))(3)(+)AsCH(2)COO(-)) in fish samples using exact matching species specific isotope dilution (ID) liquid chromatography LTQ-Orbitrap mass spectrometry (LC-LTQ-Orbitrap-MS) and standard addition LC inductively coupled plasma mass spectrometry (LC-ICPMS) is described. Samples were extracted by sonication for 30 min with high purity deionized water. An in-house synthesized (13)C enriched AsB spike was used for species specific ID analysis whereas natural abundance AsB, synthesized and characterized by quantitative (1)H NMR (nuclear magnetic resonance spectroscopy), was used for reverse ID and standard addition LC-ICPMS. With the LTQ-Orbitrap-MS instrument in scan mode (m/z 170-190) and resolution set at 7500, the intensities of [M + H](+) ions at m/z of 179.0053 and 180.0087 were used to calculate the 179.0053/180.0087 ion ratio for quantification of AsB in fish tissues. To circumvent potential difficulty in mass bias correction, an exact matching approach was applied. A quantitatively prepared mixture of the natural abundance AsB standard and the enriched spike to give a ratio near one was used for mass bias correction. Concentrations of 9.65 ± 0.24 and 11.39 ± 0.39 mg kg(-1) (expanded uncertainty, k = 2) for AsB in two fish samples of fish1 and fish2, respectively, were obtained by ID LC-LTQ-Orbitrap-MS. These results are in good agreement with those obtained by standard addition LC-ICPMS, 9.56 ± 0.32 and 11.26 ± 0.44 mg kg(-1) (expanded uncertainty, k = 2), respectively. Fish CRM DORM-2 was used for method validation and measured results of 37.9 ± 1.8 and 38.7 ± 0.66 mg kg(-1) (expanded uncertainty, k = 2) for AsB obtained by standard addition LC-ICPMS and ID LC-LTQ-Orbitrap-MS, respectively, are in good agreement with the certified value of 39.0 ± 2.6 mg kg(-1) (expanded uncertainty, k = 2). Detection limits of 0.011 and 0.033 mg kg(-1) for AsB with LC-ICPMS and ID LC-LTQ-Orbitrap-MS, respectively, were obtained demonstrating that the technique is well suited to the determination AsB in fish samples. To the best of our knowledge, this is first application of species specific isotope dilution for the accurate and precise determination of AsB in biological tissues.
Analytical Chemistry 04/2011; 83(9):3371-8. · 5.86 Impact Factor
-
Catherine A Rimmer,
Samuel B Howerton,
Katherine E Sharpless,
Lane C Sander,
Stephen E Long,
Karen E Murphy,
Barbara J Porter,
Karsten Putzbach,
Michael S Rearick,
Stephen A Wise, [......],
Ralph Sturgeon,
Brian Schaneberg,
Christina Nelson,
Jules Skamarack,
Meide Pan,
Kerri Levanseler,
Dean Gray,
Edward H Waysek,
Anne Blatter,
Eike Reich
[show abstract]
[hide abstract]
ABSTRACT: A suite of three ginkgo-containing dietary supplement Standard Reference Materials (SRMs) has been issued by the National Institute of Standards and Technology (NIST) with certified values for flavonoid aglycones, ginkgolides, bilobalide, and selected toxic trace elements. The materials represent a range of matrices (i.e., plant, extract, and finished product) that provide different analytical challenges. The constituents have been determined by at least two independent analytical methods with measurements performed by NIST and at least one collaborating laboratory. The methods utilized different extractions, chromatographic separations, modes of detection, and approaches to quantitation. The SRMs are primarily intended for method validation and for use as control materials to support the analysis of dietary supplements and related botanical materials.
Analytical and Bioanalytical Chemistry 10/2007; 389(1):179-96. · 3.78 Impact Factor
-
[show abstract]
[hide abstract]
ABSTRACT: Cold vapor generation arising from reduction of both Hg(2+) and CH(3)Hg(+) occurs using ultrasonic (US) fields of sufficient density to achieve both localized heating as well as radical-based attack in solutions of formic and acetic acids and tetramethylammonium hydroxide (TMAH). A batch sonoreactor utilizing an ultrasonic probe as an energy source and a flow through system based on a US bath were optimized for this purpose. Reduction of CH(3)Hg(+) to Hg(0) occurs only at relatively high US field density (>10 W cm(-3) of sample solution) and is thus not observed when a conventional US bath is used for cold vapor generation. Speciation of mercury is thus possible by altering the power density during the measurement process. Thermal reduction of Hg(2+) is efficient in formic acid and TMAH at 70 degrees C and occurs in the absence of the US field. Room temperature studies with the batch sonoreactor reveal a slow reduction process, producing temporally broad signals having an efficiency of approximately 68% of that arising from use of a conventional SnCl(2) reduction system. Molecular species of mercury are generated at high concentrations of formic and acetic acid. Factors affecting the generation of Hg(0) were optimized and the batch sonoreactor used for the determination of total mercury in SLRS-4 river water reference material.
Analytical and Bioanalytical Chemistry 06/2007; 388(4):849-57. · 3.78 Impact Factor
-
Zoltán Mester, Scott Willie,
Lu Yang,
Ralph Sturgeon,
Joseph A Caruso,
María Luisa Fernández,
Peter Fodor,
Robert J Goldschmidt,
Heidi Goenaga-Infante,
Ryszard Lobinski,
Paulette Maxwell,
Shona McSheehy,
Aleksandra Polatajko,
Baki B M Sadi,
Alfredo Sanz-Medel,
Christine Scriver,
Joanna Szpunar,
Raimund Wahlen,
Wayne Wolf
[show abstract]
[hide abstract]
ABSTRACT: A new selenized yeast reference material (SELM-1) produced by the Institute for National Measurement Standards, National Research Council of Canada (INMS, NRC) certified for total selenium (2,059+/-64 mg kg(-1)), methionine (Met, 5,758+/-277 mg kg(-1)) and selenomethionine (SeMet, 3,431+/-157 mg kg(-1)) content is described. The +/-value represents an expanded uncertainty with a coverage factor of 2. SeMet and Met amount contents were established following a methanesulfonic acid digestion of the yeast using GC-MS and LC-MS quantitation. Isotope dilution (ID) calibration was used for both compounds, using 13C-labelled SeMet and Met. Total Se was determined after complete microwave acid digestion based on ID ICP-MS using a 82Se spike or ICP-OES spectrometry using external calibration. An international intercomparison exercise was piloted by NRC to assess the state-of-the-art of measurement of selenomethione in SELM-1. Determination of total Se and methionine was also attempted. Seven laboratories submitted results (2 National Metrology Institutes (NMIs) and 5 university/government laboratories). For SeMet, ten independent mean values were generated. Various acid digestion and enzymatic procedures followed by LC ICP-MS, LC AFS or GC-MS quantitation were used. Four values were based on species-specific ID calibration, one on non-species-specific ID with the remainder using standard addition (SA) or external calibration (EC). For total selenium, laboratories employed various acid digestion procedures followed by ICP-MS, AFS or GC-MS quantitation. Four laboratories employed ID calibration, the remaining used SA or EC. A total of seven independent results were submitted. Results for methionine were reported by only three laboratories, all of which used various acid digestion protocols combined with determination by GC-MS and LC UV. The majority of participants submitted values within the certified range for SeMet and total Se, whereas the intercomparison was judged unsuccessful for Met because only two external laboratories provided values, both of which were outside the certified range.
Analytical and Bioanalytical Chemistry 06/2006; 385(1):168-80. · 3.78 Impact Factor
-
[show abstract]
[hide abstract]
ABSTRACT: A simple, fast method is described for the determination of Ag, As, Cd, Cu, Cr, Fe, Ni, and Se in marine biological tissues by electrothermal atomic-absorption spectrometry (ETAAS) and Na, Ca, K, Mg, Fe, Cu, and Mn by inductively coupled plasma-atomic emission spectrometry (ICP-AES). Solubilization of the biological tissue was achieved by using formic acid with vortex mixing followed by heating to 50 degrees C in an ultrasonic bath. Once solubilized, the tissues were diluted to an appropriate volume with water for analysis. Aliquots were sampled into a graphite furnace and ICP-AES using a conventional autosampler. The method was validated by use of biological certified reference materials from NRC, DORM-2, DOLT-2, DOLT-3, LUTS-1, TORT-2, and NIST SRMs 1566b and 2976. Simplicity and reduced sample-preparation time prove to be the major advantages to the technique.
Analytical and Bioanalytical Chemistry 05/2005; 381(7):1460-6. · 3.78 Impact Factor
-
[show abstract]
[hide abstract]
ABSTRACT: A method for the determination of U and Th at sub-ppt levels in high-purity Pb samples using extraction chromatography with ICPMS detection is described. Following acid digestion, uranium and thorium are separated from the lead matrix using UTEVA resin. Sorption and elution procedures were optimized, the potential reusability of the chromatographic resin was evaluated, and a performance comparison between prepacked and freshly prepared UTEVA column was made. Uranium could be eluted with 0.025 M HCl and Th then recovered using 0.5% oxalic acid. Recovery yields for U exceed 80% whereas those for Th were typically 60%. Procedural detection limits of 0.5 and 1.5 pg g(-)(1) were obtained for U and Th, respectively. For purposes of comparison, GD-MS analysis of samples was also performed, yielding results consistent with those generated by ICPMS but with inferior detection power.
Analytical Chemistry 05/2005; 77(8):2432-6. · 5.86 Impact Factor
-
[show abstract]
[hide abstract]
ABSTRACT: There is an urgent need for natural water reference materials certified for nutrients. In 1996, NRC collected seawater for a proposed CRM at a depth of 200 m in the North Atlantic; this was immediately filtered through 0.05-microm cartridge filters into 50-L carboys. The water was later homogenized in the NRC laboratories in Ottawa and stabilized via gamma irradiation. Over six years of stability testing no significant deterioration was detected. In addition to the usual customary standard colorimetric procedures, alternative analytical methods were developed to enable the certification process. The production of a CRM called MOOS-1 will be discussed. Certified values, with uncertainty components addressing the homogeneity, stability, and characterization of the material, were calculated to be: orthophosphate=1.56+/-0.07 micro mol L(-1), silicate=26.0+/-1.0 micro mol L(-1), nitrite=3.06+/-0.15 micro mol L(-1), and nitrite and nitrate=23.7+/-0.9 micro mol L(-1).
Analytical and Bioanalytical Chemistry 04/2004; 378(5):1239-42. · 3.78 Impact Factor
