-
[show abstract]
[hide abstract]
ABSTRACT: OBJECTIVE-To evaluate use of gadolinium diethylenetriamine pentaacetic acid (Gd-DTPA) to estimate glomerular filtration rate (GFR) by plasma clearance and use of an ELISA as the method of Gd-DTPA quantification. ANIMALS-16 dogs of various sexes and breeds (12 dogs were clinically normal, and 4 dogs were polyuric and polydipsic with no other clinical or biochemical abnormalities). PROCEDURES-GFR was estimated by measuring the plasma clearance of Gd-DTPA and iohexol by use of an ELISA and high-performance liquid chromatography (HPLC), respectively. The GFR was determined by use of a 1-compartment model for both methods. The GFRs obtained by Gd-DTPA plasma clearance were compared with those obtained by iohexol plasma clearance by use of correlation analysis, paired t tests, and limits of agreement analysis. A paired t test was used to evaluate differences between the 2 plasma clearance methods. RESULTS-A strong linear correlation (r(2) = 0.90) was found between GFRs derived from the plasma clearance of Gd-DTPA and those derived from the plasma clearance of iohexol. By use of limits of agreement analysis, almost all (13/14) dogs had Gd-DTPA GFRs that were within 12% of iohexol GFRs. The remaining dog had a Gd-DTPA GFR that was 45% higher than the iohexol GFR. There was no significant difference between Gd-DTPA GFRs and those obtained with iohexol. CONCLUSIONS AND CLINICAL RELEVANCE-This study revealed that plasma clearance of Gd-DTPA measured by use of an ELISA is an effective method to estimate GFR in dogs because it compared favorably with results for the iohexol-HPLC method.
American Journal of Veterinary Research 05/2009; 70(4):547-52. · 1.27 Impact Factor
-
[show abstract]
[hide abstract]
ABSTRACT: Nanoparticles are increasingly used to label cells to track them by imaging or to quantify them in vivo. However, normal cellular uptake mechanisms are inadequate to load cells with tracking label. We propose a simple method to coat nanoparticles, such as monocrystalline iron oxide nanoparticle (MION), with the transfection agent polylysine in order to facilitate rapid, uniform, and heavy labeling of fibroblasts. The method is based on commercially available reagents, requires no more than 1 h of laboratory contact time, and can be accomplished safely without a chemical hood. A suspension of MION was treated by addition of solid sodium periodate to oxidize glucose residues of dextran and introduced aldehyde groups to the dextran coat surrounding MION's crystalline magnetite core. After a 30-min incubation to effect oxidation, unreacted periodate was quenched with glycerol. The preparation was dialyzed to remove reactants and diluted to a final concentration of 2 mg Fe/ml. Poly-L-lysine was added to the oxidized MION (MION-A) to form reversible covalent Schiff base linkages. The resulting conjugate, a polylysine iron oxide nano-particle is abbreviated PLION. NIH3T3 fibroblasts labeled with either MION, MION-A, or MION plus polylysine showed minimal uptake of iron while cells labeled with PLION acquired a brown hue demonstrating strong labeling with iron. Microscopic assessment of iron labeling was confirmed using Prussian blue staining. In some cells, the concentration of iron was sufficiently high and localized to suggest association with cytoplasmic vacuoles. The nucleus of the cell was not labeled. Cell labeling increased when the ratio of polylysine to MION increased and with increasing amount of PLION.
Journal of Cardiovascular Translational Research 03/2009; 2(1):30-8. · 2.61 Impact Factor
-
American Journal of Kidney Diseases 12/2008; 52(5):1021; author reply 1021-2. · 5.43 Impact Factor
-
[show abstract]
[hide abstract]
ABSTRACT: This is the first description of functional immunoassay technology (FIT), which as a diagnostic tool has broad application across the whole spectrum of physiological measurements. In this paper, FIT is used to measure the renal clearance of an ultra low-dose administration of a clinically available contrast reagent for the purpose of obtaining an accurate glomerular filtration rate (GFR) measurement. Biomarker-based GFR estimates offer convenience, but are not accurate and are often misleading. FIT overcomes previous analytic barriers associated with obtaining an accurate GFR measurement. We present the performance characteristics of this diagnostic test and demonstrate the method by directly comparing GFR values obtained by FIT to those obtained by an FDA approved nuclear test in 20 adults. Two subjects were healthy volunteers and the remaining 18 subjects had diagnosed chronic kidney disease, with 12 being kidney transplant recipients. Measured GFR values were calculated by the classic UV/P method and by the blood clearance method. GFR obtained by FIT and the nuclear test correlated closely over a wide range of GFR values (10.9-102.1 ml.min(-1).1.73 m(-2)). The study demonstrates that FIT-GFR provides an accurate and reproducible measurement. This nonradioactive, immunoassay-based approach offers many advantages, chiefly that most laboratories already have the equipment and trained personnel necessary to run an ELISA, and therefore this important diagnostic measurement can more readily be obtained. The FIT-GFR test can be used throughout the pharmaceutical development pipeline: preclinical and clinical trials.
American journal of physiology. Renal physiology 10/2008; 295(5):F1583-8. · 3.68 Impact Factor
-
[show abstract]
[hide abstract]
ABSTRACT: Tracking cells in regenerative medicine is becoming increasingly important for basic cell therapy science, for cell delivery optimization and for accurate biodistribution studies. This report describes nanoparticles that utilize stable-isotope metal labels for multiple detection technologies in preclinical studies. Cells labeled with nanoparticles can be imaged by electron microscopy, fluorescence, and magnetic resonance. The nanoparticle-labeled cells can be quantified by neutron activation, thereby allowing, with the use of standard curves, the determination of the number of labeled cells in tissue samples from in vivo sources. This report describes the characteristics of these nanoparticles and methods for using these nanoparticles to label and track cells.
Journal of Cardiovascular Translational Research 09/2008; 1(3):217-20. · 2.61 Impact Factor
-
[show abstract]
[hide abstract]
ABSTRACT: One area that has been overlooked in the evolution of magnetic nanoparticle technology is the possibility of introducing informational atoms into the iron oxide core of the coated colloid. Introduction of suitable atoms into the iron oxide core offers an opportunity to produce a quantifiable probe, thereby adding one or more dimensions to the magnetic colloid's informational status. Lanthanide-doped iron oxide nanoparticles have been synthesized to introduce informational atoms through the formation of colloidal mixed ferrites. These colloids are designated ultrasmall mixed ferrite iron oxides (USMIOs). USMIOs containing 5 mol % europium exhibit superparamagnetic behavior with an induced magnetization of 56 emu/g Fe at 1.5 T, a powder X-ray diffraction pattern congruent with magnetite, and R1 and R2 relaxivity values of 15.4 (mM s) (-1) and 33.9 (mM s) (-1), respectively, in aqueous solution at 37 degrees C and 0.47 T. USMIO can be detected by five physical methods, combining the magnetic resonance imaging (MRI) qualities of iron with the sensitive and quantitative detection of lanthanide metals by neutron activation analysis (NA), time-resolved fluorescence (TRF), X-ray fluorescence, along with detection by electron microscopy (EM). In addition to quantitative detection using neutron activation analysis, the presence of lanthanides in the iron oxide matrix confers attractive optical properties for long-term multilabeling studies with europium and terbium. These USMIOs offer high photostability, a narrow emission band, and a broad absorption band combining the high sensitivity of time-resolved fluorescence with the high spatial resolution of MRI. USMIO nanoparticles are prepared through modifications of traditional magnetite-based iron oxide colloid synthetic methods. A 5 mol % substitution of ferric iron with trivalent europium yielded a colloid with nearly identical magnetic, physical, and chemical characteristics to its magnetite colloid parent.
Bioconjugate Chemistry 18(6):1763-71. · 4.93 Impact Factor
