Publications (5)0 Total impact
-
Conference Proceeding: Performance of a far-IR TES bolometer on monolithic sapphire membrane
Optical Sensing, Brian Culshaw; Anna G. Mignani; Rainer Riesenberg, Editors, pp.76-80; 09/2004 -
Article: Photonics Europe
[show abstract] [hide abstract]
ABSTRACT: The performance of a high Tc (~90 K) transition-edge superconducting (TES) bolometer on a monolithic sapphire membrane is presented and discussed. It is compared to the performance of a previous TES bolometer on non-monolithic sapphire substrate. The development and optimization of monolithic sapphire membranes is critical for the fabrication of 1 and 2-D arrays of TES bolometers. Moderately cooled and optimized TES bolometers are expected to be the replacements of choice for thermopiles and other room temperature thermal sensors on far IR instruments on future planetary missions.© (2004) COPYRIGHT SPIE--The International Society for Optical Engineering. Downloading of the abstract is permitted for personal use only.08/2004; -
Article: In-flight Far-Infrared Performance of the CIRS Instrument on Cassini
[show abstract] [hide abstract]
ABSTRACT: The Composite Infrared Spectrometer (CIRS) on-board Cassini consists of two interferometers: a conventional Michelson for the mid-infrared; and a Martin-Puplett type in the far-infrared employing wire grid polarizers to split, recombine and analyze the radiation. The far-IR focal plane (FP1) assembly uses two thermopile detectors to measure the final transmitted and reflected beams at the polarizer-analyzer: if one fails, the interferometer can still operate, albeit with a lower efficiency. The combined effect is for good response from 10 to 300/cm, and declining response to 600/cm. This paper will examine in-flight performance of the far-IR interferometer, including NESR and response. Regular noise spikes, resulting from pickup from other electrical sub-systems has been found on the CIRS interferograms, and the removal of these effects is discussed. The radiometric calibration is described, and then we show how the calibration was applied to science data taken during the Jupiter flyby of December 2000. Finally, we discuss signal-to-noise on the calibrated spectra, emphasizing limitations of the current instrument and the potential for improvement in future missions.03/2004; -
Article: The Case for Moderately-Cooled, Far-Infrared Thermal Detectors
[show abstract] [hide abstract]
ABSTRACT: There are moderately-cooled (around 77K) infrared detectors, for instance InSb (around 5 microns wavelength) and HgCdTe (around 15 to 20 microns wavelength). However for longer wavelengths there are either uncooled thermal-type detectors or highly cooled (about 4K and lower) quantum and thermal detectors, with the notable exception of high Tc superconductor detectors. We will describe certain long-wavelength applications in space where only moderate cooling is feasible, and where better sensitivity is required than possible with uncooled detectors. These requirements could be met with high Tc bolometers, but it may also be prudent to develop other technologies. Additionally, over the past 16 years a marketplace has not developed for the commercial production of high Tc bolometers, indicating their production may be a natural endeavor for government laboratories.03/2004; -
Article: The Case for Moderately-Cooled, Far-Infrared Thermal Detectors
[show abstract] [hide abstract]
ABSTRACT: There are moderately-cooled (around 77K) infrared detectors, for instance InSb (around 5 microns wavelength) and HgCdTe (around 15 to 20 microns wavelength). However for longer wavelengths there are either uncooled thermal-type detectors or highly cooled (about 4K and lower) quantum and thermal detectors, with the notable exception of high Tc superconductor detectors. We will describe certain long-wavelength applications in space where only moderate cooling is feasible, and where better sensitivity is required than possible with uncooled detectors. These requirements could be met with high Tc bolometers, but it may also be prudent to develop other technologies. Additionally, over the past 16 years a marketplace has not developed for the commercial production of high Tc bolometers, indicating their production may be a natural endeavor for government laboratories.
