Publications (2)4.15 Total impact
-
Article: Measurement of patient skin dose in vertebroplasty using radiochromic dosimetry film.
[show abstract] [hide abstract]
ABSTRACT: We studied the radiation doses to which patients were exposed during 17 vertebroplasty operations. The radiation doses during vertebroplasty were measured to determine maximum skin dose (MSD), a measure of the likelihood of radiation-induced skin effects. Vertebroplasty is performed with use of fluoroscopic guidance for needle placement and to monitor bone cement injection. This procedure requires relatively long duration of fluoroscopic guidance, and so, it demands dose measurements for patients. From May 2006 to April 2008, 16 patients (7 men and 9 women; mean age 70.19 years, range 30-87 years) underwent a total of 17 vertebroplasty procedures. Total dose-area product (DAP), duration of fluoroscopy, and the parameters for anteroposterior (AP) and lateral (LAT) fluoroscopic and fluorography projections were recorded for each procedure. Gafchromic films were placed on the patients' skin to measure entrance surface dose and to evaluate the MSD. The MSD and DAP were higher in the LAT plane than in the AP plane. These results were expected because the fluoroscopy time was longer, and the number of fluorography runs was higher in the LAT plane than in the AP plane.The MSD values for the AP plane ranged between 0.184 Gy and 1.834 Gy, whereas those for the LAT plane ranged between 0.417 Gy and 2.362 Gy. The frequency distribution of values for both planes showed that most MSD values were in the range of 0 to 0.5 Gy and 0.5 to 1 Gy for the AP plane and 0.5 to 1 Gy and 1 to 1.5 Gy for the LAT plane. There was great variability in the MSD at each value for the parameters among individual instances. When evaluating the MSD to a patient, a distinction should be made between AP and LAT projections, because an overall mean MSD value underestimates the contribution of x-ray absorption on the LAT plane. The use of radiochromic films to estimate radiation damage to the skin has been shown to have the limitation of relying on DAP values only.Spine 06/2010; 35(13):1304-6. · 2.08 Impact Factor -
Article: Radiochromic films for improved evaluation of patient dose in liver interventions.
[show abstract] [hide abstract]
ABSTRACT: To investigate a method for evaluation of the maximum skin dose (MSD) of radiation in patients undergoing interventional radiology procedures in the liver. Transarterial chemoembolization, transarterial embolization, portal vein embolization, and biliary interventions were the procedures considered in this study. Ninety procedures in 70 patients were studied. The complexity of the biliary interventions was taken into account during the analysis. The MSD was measured with use of GAF chromic XR type R films, whereas the dose-area product (DAP) was measured by a transmission chamber. The MSD was measured in a group of 19 patients. The coefficient of the interpolation line between the skin dose and the DAP (0.0051 cm(-2)) was determined. An approximated value of MSD from the DAP for the remaining 71 procedures was estimated by means of an interpolation line. The mean MSD in the endovascular procedures was 4.4 Gy; for the three different levels of complexity of the biliary procedures, the mean MSDs were 0.4, 1.2, and 3 Gy, respectively. Radiochromic films are an easy-to-use and efficient method for measuring skin entrance radiation dose and have the advantage of providing information on the MSD as well as the distribution of radiation to the skin. In light of these results, the authors suggest recording the dose for biliary and endovascular procedures as indicated by the International Commission on Radiological Protection and the United States Food and Drug Administration.Journal of Vascular and Interventional Radiology 06/2006; 17(5):855-62. · 2.08 Impact Factor
Top co-authors
Top Journals
Institutions
-
2010
-
Policlinico San Matteo Pavia Fondazione IRCCS
Pavia, Lombardy, Italy
-
