Dispersion and Reduction of Copper Oxide Supported on WO 3 -Modified Ce 0.5 Zr 0.5 O 2 Solid Solution

Key Laboratory of Mesoscopic Chemistry, Department of Chemistry, Nanjing University, Nanjing 210093, People's Republic of China.
The Journal of Physical Chemistry B (Impact Factor: 3.3). 04/2005; 109(9):3949-55. DOI: 10.1021/jp046731t
Source: PubMed


XRD (X-ray diffraction), BET (Brunauer-Emmett-Teller), LRS (laser Raman spectra), XPS (X-ray photoelectron spectroscopy), and TPR (temperature-programmed reduction) are used to investigate the surface properties of CuO/WO3/Ce(0.5)Zr(0.5)O2 samples. The results indicate that (1) tungsten oxide can be highly dispersed on Ce(0.5)Zr(0.5)O2 (denoted as CZ hereafter) solid solution, with a dispersion capacity of about 0.8 mmol WO(3)/(100 m2 CZ), and comparatively, the supported tungsten oxide species are preferentially interacted with ceria component on the surface of CZ; (2) for CuO/WO3/CZ samples with a half-monolayer WO3 loading, i.e., xCu-0.4W-CZ series, the surface of CZ is only partially covered by the preloaded WO3) and the supported copper oxide species are dispersed on the remaining surface vacant sites on CZ as well as on top of the preloaded tungsten oxide, while for the samples preloaded with a full-monolayer WO3, i.e., xCu-0.8W-CZ series, only dispersed on the top of the preloaded tungsten oxide monolayer; (3) the effect of the loading amount of WO3 on the reduction property of Cu2+ ions in a series of CuO/WO3/CZ samples has been observed and tentatively attributed to the formation of WO3 monolayer on CZ and the different coordination environments of the dispersed Cu2+ ions are discussed on the basis of the consideration of the incorporation model proposed previously (Chen, Y.; Zhang, L. Catal. Lett. 1992, 12, 51).

20 Reads
  • Source
    [Show abstract] [Hide abstract]
    ABSTRACT: Ce0.5Zr0.5O2 solid solution was synthesized by a microwave method and used as support for preparing a series of CuO/Ce0.5Zr0.5O2 catalysts. The samples were characterized by X-ray diffraction (XRD), transmission electron microscopy (TEM), Brunauer-Emmett-Teller (BET) and temperature-programmed reduction (TPR), and the results indicated that: (1) the dispersion capacity of copper oxide on Ce0.5Zr0.5O2 is about 0.70mmolCuO/100m2Ce0.5Zr0.5O2; (2) there are two kinds of copper species in the catalysts, i.e., dispersed and crystalline copper species. The catalytic activities of CuO/Ce0.5Zr0.5O2 for the low temperature (100 and 125°C) CO oxidation were also tested, which showed that the sample with CuO loading amount of 1.2mmolCuO/100m2Ce0.5Zr0.5O2 presented the highest activity. Combined with the XRD and TPR results, it seems to suggest that the main active species in this system should be the surface and/or small particle copper oxide species.
    Journal of Molecular Catalysis A Chemical 08/2006; 255(1):254-259. DOI:10.1016/j.molcata.2006.04.015 · 3.62 Impact Factor
  • [Show abstract] [Hide abstract]
    ABSTRACT: The TiO2-N-x%WO3 composite photocatalysts were prepared by introducing WO3 into nitrogen-doped TiO2. The composite catalysts present much higher photocatalytic activity than TiO2 and nitrogen-doped TiO2 under both ultraviolet and visible light irradiation. Diffuse reflectance UV-vis spectra, XPS analysis, and IR spectra show that the coordinated nitrogen species (or N-metal-O linkages) may contribute to the visible light photocatalytic activity. WO3 coupling increases the active nitrogen species and thus enhances the visible light activity of the composite photocatalysts. The superior activity of TiO2-N-x%WO3 composite photocatalysts upon UV light irradiation can be rationalized in terms of efficient charge separation and high adsorption affinity of WO3.
    The Journal of Physical Chemistry B 08/2006; 110(29):14391-7. DOI:10.1021/jp0624606 · 3.30 Impact Factor
  • Source
    [Show abstract] [Hide abstract]
    ABSTRACT: A WO3/CeO2-ZrO2 catalyst system was discovered for selective catalytic reduction of NOx with NH3; the catalyst (10 wt% WO3 loading) showed nearly 100% NOx conversion in a temperature range of 200-500 degrees C, at a space velocity of 90 000 h(-1) in a simulated diesel exhaust containing 550 ppm NOx (NO : NO2 feed ratio at 1.0), 10 vol% H2O and 10 vol% CO2; the catalyst also exhibited high temperature stability.
    Chemical Communications 04/2008; 12(12):1470-2. DOI:10.1039/b717873e · 6.83 Impact Factor
Show more