Multi-component reactions in supramolecular chemistry and material science.

Leibniz Institute of Plant Biochemistry, Halle(Saale), Weinberg 3, D-06120, Germany, .
Advances in Experimental Medicine and Biology (Impact Factor: 1.96). 01/2011; 699:173-201. DOI: 10.1007/978-1-4419-7270-5_6
Source: PubMed

ABSTRACT Multi-component reactions of building blocks with more than one MCR-reactive group will give rise to oligomeric MCR products.
The proper choice of at least two bifunctional building blocks will give either a polymeric or a cyclic product. Apart from
polymerization, repetitive or consecutive Ugi reactions have been used to produce linear MCR-heterooligomers with such building

1 Follower
13 Reads
  • [Show abstract] [Hide abstract]
    ABSTRACT: A reaction between levulinic acid, isocyanides and primary amines has been examined in distilled water and in surfactants solutions. It is demonstrated that the reaction gives good results at the different concentrations including one well above the solubility limit. A simple and eco-friendly protocol for libraries production is described.
    Molecular Diversity 06/2004; 6(3-4):193-7. DOI:10.1002/chin.200426093 · 1.90 Impact Factor
  • [Show abstract] [Hide abstract]
    ABSTRACT: ChemInform is a weekly Abstracting Service, delivering concise information at a glance that was extracted from about 200 leading journals. To access a ChemInform Abstract, please click on HTML or PDF.
    Synlett 07/2006; 37(4):0615-0617. DOI:10.1055/s-2006-933104 · 2.42 Impact Factor
  • Source
    [Show abstract] [Hide abstract]
    ABSTRACT: The objective of this work was to investigate NOx removal with a hybrid system consisting of a dc corona discharge and a catalyst at a room temperature (22 °C) in the presence of ammonia. The experimental procedure was as follows. A positive dc corona discharge was generated between a stainless steel hollow needle and a flat mesh made of brass. The needle was placed perpendicularly to the mesh maintaining the interelectrode distance of 40 mm. The outer and inner diameters of the hollow needle were 2 and 1.6 mm, respectively. The catalyst used in this investigation was a layer of V2O5 and TiO2 deposited on Al2O3 globules of 5–6 mm in diameter. They were placed on the mesh so that the distance between the tube and the globules was 30 mm. The catalyst was either saturated with NH3 or free of NH3. A gas mixture of N2 (80%):O2 (5%):CO2 (15%):NO (200 ppm) flowed through the tube with a flow rate of 1 l/min. Ammonia was added to the gas mixture through a hollow needle in a concentration of either 400 ppm when NH3-free catalyst was used or 30 ppm when catalyst saturated with NH3 was used. Results of the investigation showed that the hybrid system (with NH3-saturated catalyst) removes up to 96% of NOx with an energy efficiency of 3.4 g NO/kWh. Without the catalyst, NOx removal in the “pure” corona discharge in the gas mixture with ammonia was lower (up to 66%). Also the energy efficiency was lower (about 1.8 g NO/kWh). The obtained results showed that the investigated corona discharge-catalyst hybrid system is attractive for NOx removal because of relatively high efficiency both in NOx decomposition and energy consumption.
    Catalysis Today 02/2004; 89(1-89):127-133. DOI:10.1016/j.cattod.2003.11.031 · 3.89 Impact Factor