Teng, J. et al. Athermal silicon-on-insulator ring resonators by overlaying a polymer cladding on narrowed waveguides. Opt. Express 17, 14627-14633

Photonics Research Group, INTEC-department, Ghent University-IMEC, Ghent, B-9000, Belgium.
Optics Express (Impact Factor: 3.49). 09/2009; 17(17):14627-33. DOI: 10.1364/OE.17.014627
Source: PubMed


Athermal silicon ring resonators are experimentally demonstrated by overlaying a polymer cladding on narrowed silicon wires. The ideal width to achieve athermal condition for the TE mode of 220 nm-height SOI waveguides is found to be around 350 nm. After overlaying a polymer layer, the wavelength temperature dependence of the silicon ring resonator is reduced to less than 5 pm/degrees C, almost eleven times less than that of normal silicon waveguides. The optical loss of a 350-nm bent waveguide (with a radius of 15 microm) is extracted from the ring transmission spectrum. The scattering loss is reduced to an acceptable level of about 50 dB/cm after overlaying a polymer cladding.

Download full-text


Available from: Xiuyou Han, Apr 01, 2014
34 Reads
  • Source
    • "There are mainly three kinds of approaches. The first one is to utilize the opposite thermo optic coefficients (TOCs, dn/dT) of the water solution (dn/dT: $ À10 À 4 /K [11]) and the waveguide core (Si 3 N 4 , SiO 2 : $10 À 5 /K [12]; Si: $ 10 À 4 /K [13]), which is derived from the athermalization of optical waveguide filter devices with the negative TOC of polymer or TiO 2 as the upper cladding [14] [15] [16]. In [17] the slot waveguide of silicon-on-isolator (SOI) was proposed to distribute properly the optical power between sample and silicon aiming to give athermal operation. "
    [Show abstract] [Hide abstract]
    ABSTRACT: The temperature sensitivity of optical waveguide microring (MR) is the critical factor to influence the performance of MR-based biosensor. An athermal MR-based biosensor with intensity interrogation is proposed and analyzed. The integrative biosensor chip is composed of sensing unit MR and interrogation unit Mach–Zehnder interferometer (MZI) with the same temperature sensitivity. The resonant wavelength shift of MR by temperature change is equal to the center wavelength shift of interrogation curve of MZI which cancel with each other during interrogation process. The polymer based integrative biosensor chip is designed and investigated. The simulation results show that the temperature sensitivity of the polymer waveguide biosensor is smaller than 1 pm/K with the temperature change between −10 K to 20 K relative to the reference temperature 20 °C and refractive index change from 0 to 0.05. The intensity interrogation method utilizing the power ratio between the two output ports of MZI has the flexibility of selecting large linear range and high resolution and is immune to output power fluctuations of the light source.
    Optics Communications 12/2015; 356:41-48. DOI:10.1016/j.optcom.2015.07.036 · 1.45 Impact Factor
  • Source
    • "(B) Calculated wavelength temperature dependence of the TE mode as a function of waveguide widths. Reprinted with permission from Ref. [24], copyright (2009) OSA. "
    [Show abstract] [Hide abstract]
    ABSTRACT: Silicon microring resonators have been hailed for their potential use in next-generation optical interconnects. However, the functionality of silicon microring based devices suffer from susceptibility to thermal fluctuations that is often overlooked in their demonstrated results, but must be resolved for their future implementation in microelectronic applications. We survey the emerging efforts that have been put forth to resolve these thermal susceptibilities and provide a comprehensive discussion of their advantages and disadvantages.
    Nanophotonics 08/2014; 3(4-5). DOI:10.1515/nanoph-2013-0013 · 5.69 Impact Factor
  • Source
    • "Si) CMOS electronics platform, group-IV photonics has been widely investigated, and significant progress has been made. This has included the development of waveguides [8], [9] as well as various types of modulators [2], [10]–[12] and photodetectors [13]–[15]. However, the monolithic integration of group-IV electrically injected laser diodes with the CMOS platform remains a key component that has been missing thus far. "
    [Show abstract] [Hide abstract]
    ABSTRACT: In this paper, a theoretical analysis of unstrained GeSn alloys as a laser gain medium was performed. Using the empirical pseudopotential method, the band structure of GeSn alloys was simulated and verified against experimental data. This model shows that GeSn becomes direct bandgap with 6.55% Sn concentration. The optical gain of GeSn alloys with 0-10% Sn concentration was calculated with different n-type doping concentrations and injection levels. It is shown theoretically that adding Sn greatly increases the differential gain owing to the reduction of energy between the direct and indirect conduction bands. For a double-heterostructure laser, the model shows that at a cavity loss of 50 cm-1, the minimum threshold current density drops 60 times from Ge to Ge0.9Sn0.1, and the corresponding optimum n-doping concentration of the active layer drops by almost two orders of magnitude. These results indicate that GeSn alloys are good candidates for a Si-compatible laser.
    IEEE Journal of Selected Topics in Quantum Electronics 09/2013; 19(5-5):1502706-1502706. DOI:10.1109/JSTQE.2013.2241397 · 2.83 Impact Factor
Show more