Article

Thermal and laser properties of Nd:Lu3Sc1.5Ga3.5O12 for high power dual-wavelength laser

State Key Laboratory of Crystal Materials, Shandong University, Jinan 250100, China.
Optics Express (Impact Factor: 3.53). 03/2012; 20(7):6944-51. DOI: 10.1364/OE.20.006944
Source: PubMed

ABSTRACT We measured the thermal properties of Nd:Lu₃Sc₁.₅Ga₃.₅O₁₂ (Nd:LuSGG) crystal, including the thermal expansion coefficient, specific heat, and thermal diffusion coefficient. The calculated thermal conductivity is 4.4 W/mK at room temperature. A high-power continuous-wave and passively Q-switched Nd:LuSGG laser was also demonstrated. Continuous-wave output power of 6.96 W is obtained which is the highest power with this material. For the first time to our knowledge, the passively Q-switched Nd:LuSGG laser is reported with the shortest pulse width, largest pulse energy, and highest peak power are achieved to be 5.1 ns, 62.5 μJ, and 12 kW, respectively. By spectral analysis, it has been found that the Nd:LuSGG laser was located at 1059 nm under low pump power, and became dual-wavelength at 1061.5 and 1059 nm when the incident pump power is over 2.27 W. The generating mechanism of dual-wavelength laser is also discussed.

0 Followers
 · 
101 Views
  • [Show abstract] [Hide abstract]
    ABSTRACT: A neodymium-doped gadolinium scandium gallium garnet (Nd:GSGG) single crystal with dimensions of Φ 5 × 20 mm2 has been grown by means of optical floating zone (OFZ). X-ray powder diffraction (XRPD) result shows that the as-grown Nd:GSGG crystal possesses a cubic structure with space group Ia3d and a cell parameter of a = 1.2561 nm. Effective elemental segregation coefficients of the Nd:GSGG as-grown crystal were calculated by using X-ray fluorescence (XRF). The thermal properties of the Nd:GSGG crystal were systematically studied by measuring the specific heat, thermal expansion and thermal diffusion coefficient, and the thermal conductivity of this crystal was calculated. The absorption and luminescence spectra of Nd:GSGG were measured at room temperature (RT). By using the Judd-Ofelt (J-O) theory, the theoretical radiative lifetime was calculated and compared with the experimental result. Continuous wave (CW) laser performance was achieved with the Nd:GSGG at the wavelength of 1062 nm when it was pumped by a laser diode (LD). A maximum output power of 0.792 W at 1062 nm was obtained with a slope efficiency of 11.89% under a pump power of 7.36 W, and an optical-optical conversion efficiency of 11.72%.
    Optical Materials 12/2013; 36(2):521-528. DOI:10.1016/j.optmat.2013.10.024 · 2.08 Impact Factor
  • [Show abstract] [Hide abstract]
    ABSTRACT: Based on the anisotropy of laser crystal, we demonstrate a method of adjusting laser emission by selecting crystal orientation. When the light propagating direction varies from a to c axis of Nd:LiGd(MoO4)2 crystal, emission wavelength exhibits a sensitive change of 1061 nm → 1061/1062 + 1068 nm → 1068 nm. The experimental discipline is well explained by a theoretical study of simulating on the spatial distribution of stimulated emission cross-section. This letter manifests that the laser property along non-principal-axis direction is also valuable for research and application, which breaks through the traditional custom of using laser materials processed along principal-axis.
    Applied Physics Letters 01/2013; 102(1). DOI:10.1063/1.4775383 · 3.52 Impact Factor
  • Source
    [Show abstract] [Hide abstract]
    ABSTRACT: Multi-wavelength emissions have been demonstrated in many disordered laser crystals. Improving the emission controllability is crucial for their practical applications. However, it is difficult because the closely adjacent laser components cannot be effectively adjusted by the traditional resonator design. In this paper, the anisotropy of laser emission in a monoclinic, disordered crystal Nd:LuYSiO<sub>5</sub> (Nd:LYSO) is reported for the first time. By selecting crystal orientation, high power laser emission with different wavelengths and polarizations were obtained. For X-cut sample, 1076 nm single-wavelength laser output reached 7.56 W, which will be a useful light source for detecting carbonyl-hemoglobin and nitrite after frequency doubling. For Y- and Z-cut samples, 1076, 1079 nm dual-wavelength laser output reached 10.3 W and 7.61 W, with parallel and orthogonal polarizations, respectively, which are convenient to be used as the generation sources of 0.78 THz wave by type-I or type-II difference frequency. The output characteristic is well explained by a theoretical analysis on the stimulated emission cross-section. The present work reveals that the intrinsic anisotropy in disordered laser crystal can be utilized to elevate the emission controllability. Accordantly, the material's application scopes can be extended.
    Optics Express 02/2014; 22(3):2228-35. DOI:10.1364/OE.22.002228 · 3.53 Impact Factor