Article

3D branched nanowire heterojunction photoelectrodes for high-efficiency solar water splitting and H-2 generation

Department of Electrical and Computer Engineering, University of California, San Diego, 9500 Gilman Drive, La Jolla, CA 92093, USA.
Nanoscale (Impact Factor: 6.74). 03/2012; 4(5):1515-21. DOI: 10.1039/c2nr11952h
Source: PubMed

ABSTRACT We report the fabrication of a three dimensional branched ZnO/Si heterojunction nanowire array by a two-step, wafer-scale, low-cost, solution etching/growth method and its use as photoelectrode in a photoelectrochemical cell for high efficiency solar powered water splitting. Specifically, we demonstrate that the branched nanowire heterojunction photoelectrode offers improved light absorption, increased photocurrent generation due to the effective charge separation in Si nanowire backbones and ZnO nanowire branching, and enhanced gas evolution kinetics because of the dramatically increased surface area and decreased radius of curvature. The branching nanowire heterostructures offer direct functional integration of different materials for high efficiency water photoelectrolysis and scalable photoelectrodes for clean hydrogen fuel generation.

Download full-text

Full-text

Available from: Deli Wang, Jul 01, 2015
2 Followers
 · 
347 Views
  • Source
    [Show abstract] [Hide abstract]
    ABSTRACT: Hydrogenated ZnO nanorod arrays (NRAs) grown on F-doped SnO(2) (FTO) glass substrates yield a benchmark specific hydrogen production rate of 122,500 μmol h(-1) g(-1), and exhibit excellent stability and recyclability.
    Chemical Communications 04/2012; 48(62):7717-9. DOI:10.1039/c2cc31773g · 6.72 Impact Factor
  • [Show abstract] [Hide abstract]
    ABSTRACT: We report a nickel oxide (NiOx) thin film, from a cost-effective sol–gel process, coated n-type silicon (n-Si) as a photoanode for efficient photo-oxidation of water under neutral pH condition. The NiOx thin film has three functions: (i) serves as a protection layer to improve the chemical stability of the Si photoelectrode, (ii) acts as an oxygen evolution catalyst, and (iii) provides junction photovoltage to further reduce overpotential. The oxygen evolution onset potential is reduced to below the thermodynamic water oxidation level and oxygen evolution was observed at low overpotentials. Our results demonstrate the fabrication of robust photoelectrodes from low-cost NiOx and Si, which enable a practical solar water oxidation with high efficiency.
    Energy & Environmental Science 06/2012; 5(7):7872-7877. DOI:10.1039/C2EE21708B · 15.49 Impact Factor
  • Source
    [Show abstract] [Hide abstract]
    ABSTRACT: Urea has been considered as a potential hydrogen source, while the conventional methods to extract hydrogen from urea are typically energy intensive processes. Here we report the first demonstration of solar driven hydrogen releasing from urea and human urine in a photoelectrochemical cell, with the assistance of Ni(OH)2 modified metal oxide photoelectrodes (e.g., TiO2 and α-Fe2O3). Ni(OH)2 serves as a urea oxidation catalyst. Under light illumination, photoexcited holes generated at the metal oxide electrode oxidize urea, while photoexcited electrons reduce water to produce hydrogen gas at the Pt counter electrode. Urea oxidation was achieved under a small external bias or even at zero bias. Significantly, we observed continuous and stable hydrogen evolution at the Pt electrode in both urea and human urine electrolyte solutions under AM 1.5G (100 mW cm−2) light illumination. This work presents a safe, low energy cost, environmentally friendly and sustainable method to produce hydrogen, and simultaneously treat urine.
    Energy & Environmental Science 07/2012; 5(8):8215-8219. DOI:10.1039/C2EE22087C · 15.49 Impact Factor