Sarvar Rasheed

Publications (2) View all

• Source

  Available from: Sarvar Rasheed

  Dataset: comparison of micro-holes produced by micro-EDM with Laser Machining

  mohammed sarvar rasheed
• Source

  Available from: Sarvar Rasheed

  Article: Analysis of Influence of micro-EDM parameters on MRR, TWR and Ra in Machining NI-Ti Shape Memory ALloy

  mohammed sarvar rasheed, A.M. Ahmari, A.M.El-Tamimi, Mustufa H.Abidi
  [show abstract] [hide abstract]
  ABSTRACT: ISSN: 2277-3878, Volume-1, Issue-4, October 2012 32  Abstract— In the micro-machining and MEMS industry, micro-Electrical discharge machining (µ-EDM) is an important process. In this paper, the Taguchi design approach has been employed to investigate the micro-EDM parameters in order to achieve the highest Material Removal Rate (MRR), good surface quality and low Tool Wear Rate (TWR) while machining Ni-Ti based Shape Memory Alloy (SMA). Based on these investigations, it has been observed that MRR is highly influenced by capacitance, discharge voltage and depends upon electrode material. TWR and Ra were found to be better at low energy levels. Tungsten electrode is recommended for better surface roughness and brass electrode for better MRR. SEM images have been used to observe the dimensional accuracy of micro-holes produced. Index Terms—micro-EDM, micro-holes, Ni-Ti Shape Memory Alloy.
  International Journal of recent technology and Engineering. 10/2012;